Network Security

ASDM is included in the 5512 or not ?

Hi. I was wondering how I can go about routing traffic from 1 VPN tunnel to another. For example: Site A Subnet: 10.1.1.10 Site B Subnet: 10.1.1.20 Site C Subnet: 10.1.1.30 If I have point A as my main middle location, and point B and C as my spoke ...

Hi Team, Can anyone help us in our problem regarding in our Standby firewall it shows failed status. Our temporary solution is we shutdown the primary firewall because when the primary is up the status of our failover is active-active. Is there any w...

I am just adding a new switch to my network, so I copied the configuration of an existing switch to this new switch but I have a question Do I have to edit the SSH configuration or I can copy the same configuration. The switches are authenticating wi...

I am just adding a new switch to my network, so I copied the configuration of an existing switch to this new switch but I have a question Do I have to edit the SSH configuration or I can copy the same configuration. The switches are authenticating wi...

I have two ASA firewall connected to ISP using PPPOE interface and I want to confiigure A/S faillover but I get message saying : you can't configure faillover with named interface configured as PPPOE or DHCP , so any work around for this ? why they m...

Hello everyone, Our company uses two Cat 6509 chassis in VSS mode each having it’s own FWSM-2 module. Recently one of these modules failed and we sent it to a non-official hardware repair company to be repaired. This module had 100 virtual context li...

Okay before our SF upgrade, we had 2 ASA 5555x's in active standby mode.. I then broke the failover config and removed the standby ASA, running on Primary only. I upgraded the 2ndary ASA to latest release and added the SFR module etc Installed the Fi...

Hi All,I have recently set-up a redundant link on our ASA, part of the config below:interface GigabitEthernet0/0 (Primary ISP) nameif outside security-level 0 ip address A.A.A.A 255.255.255.240 standby x.x.x.x!interface GigabitEthernet0/1 nameif insi...

Hello Team,We are in building of the new Cisco ASA 5585 Firewall cluster and racked both the devices there is some issue in Primary Firewall device hence as of now we need to configure the secondary device. Once Primary device received we need to add...

HiI am trying to configure two ASA-5505 as a failover pair.Software 8.2.5 and ASDM 6.4.5.206Using the wizard i get to step3 .. then nothing happenes.Trying direct in asdm but the only interface i can choose is "--None Unnamed-"How do i get any furthe...

Hello, This is my first post, so i applogise in advance if this is a stupid question. The managment at my company want me to set up a blacklist on out external facing ASA 5540. I set up a network object group the explictly denies any incomming traff...