Network Security

Dear All.i have one  Cisco firesight mgmt center i.e 750 chasis,1u &2 cisco FirePower 8250 chassis i have connected the Cisco firesight mgmt center i.e 750 via console and have done initial configuration i.e IP, DNS , User name Now for cisco FirePowe...

does 5506 support the SSL policy? I saw in Firesight "SSL"... my version is 5.4.1.1.

Hello, Please is there any website where i can find descriptions of all the alerts that appears on the Sourcefire IPS ?  Thank you, 

Hi,I have installed in the company that I work, a ASA 5555 with FirePower, and configured Defense Center (FireSight) to access control web sites. And I see that for many times, the users must have use a refresh browser (F5) to access web sites.In the...

Hi, How can I get the all syslog references in ACS 5.6? Actually one of my clients need to analysis syslogs through Splunk.  Regards, yjung

Hello How can the Sourcefire inspect the SSL traffic? Stay pending for an answer, thanks a lot.

Does SSL inspection work if the Sourcefire appliance is connected in passive mode (not inline mode) ?  Note I have an appliance with  built-in SSL inspection (not a single appliance). Appreciate your detailed answer. Thanks, Mahmoud Seif

Hia few days ago I detected an IPv6 outage in Internet connectivity.I finaly found that the Problem occurs between the ASA 5550 (9.1.1) and the core Switch (Cat 6500 VSS (12.2(17r)SX7)).As soon the Problem occours the neighbor discovery for the core ...

Hello,I have here a passive deployment of a FirePower Appliance. Unfortunately there are around 40 hosts which get tagged as ESX Servers...which is not correct. Are there ways to optimize the OS detection? I know of NMAP scans, are there other option...

Hi Team, Please help me on this issue on ASA.  1. Failed to forward traffic for a specific IP 2. That specific ip is previously allowed on the firewall and it was working properly 3. Packet tracer output is fine 4. Flag is saA Thank you for your help...

Hi, I was just wondering if there is a way to wipe the configuration for the SFR module in a 5506? Basically I'd like to get back to the point when you first session into the SFR and you're greeted with the EULA and then the setup page. I've just upd...

Dear all, I CAN access my new asa5512 (version9.12) by asdm-731-101. But I CANNOT access by asdm-743 in same setting!! My asa is Security Plus license and I have uninstall old asdm windows program and download new asdm by webpage But still can't conn...