Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, I'm trying to open up port 2001 to my alarm company and I don't seem to be having any success. Here's my config:  Hardware:   ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores):ASA Version 9.4(1)!names!interface GigabitE...

kjatsicisco by Community Member
  • 897 Views
  • 2 replies
  • 0 Helpful votes

Hello all, I have been using a PIX 501 running 6.3(5) as my home gateway router for years. Over the last year or so I have had intermittent problems with users getting access to the internet...mainly when guests come to the house.  And in the last mo...

rolinger1 by Community Member
  • 718 Views
  • 3 replies
  • 0 Helpful votes

Hey Folks,I was reviewing the capabilities of the Cisco ASA 5585x Firewalls and I noticed that they have the ability to tie Identities to Firewall Rules. I had a lengthy conversation with a technical Cisco resource and understand the capability (whic...

NeilRerup by Community Member
  • 984 Views
  • 2 replies
  • 0 Helpful votes

Resolved! IPSec VPN Tunnel

Hi, I have established an IPSec VPN Connection, and created access list to allow traffic to some internal resources through VPN. But when I try to allow internet access to an internal resource by using NAT, the VPN to this resource be disconnected. ...

Hi, I need to ping host 211.25.206.253 from Internet. The IP is a nat from a inside IP 10.200.200.5. I attached the config. I read through some of the same problem in the forum, but it just not working. Please help to isolate the problem. !interface...

man3mar3n by Level 1
  • 706 Views
  • 2 replies
  • 0 Helpful votes

I need some advice to done a NAT configuration on ASA. First of all, please see attached simple topology scheme.The configuration of NAT is that all LOCAL LAN traffic of inside ASA side must be nat'ed to 10.52.13.0/24 subnet when the destination traf...

wkamil123 by Level 4
  • 3318 Views
  • 5 replies
  • 0 Helpful votes

Hi All, I want to setup port forwarding in Cisco ASA (5512-x/ASDM 7.4). The scenario : Outside interface directly connected to Internet, Inside interface directly connected to Web server. NAT and ACL already setup but I want to telnet web server usin...

khoirul.iman by Community Member
  • 3934 Views
  • 8 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card