Network Security

hi, i have  5 branch office and 1 head office . i am using 8.6 version in HO and 8.2 version in other  branch firewall. a lotof time i found VPN stop decrypt/encrypt packets.then i use packet tracer to allow then vpn start work automatically. please ...

 Hi friendsIf telnet traffic passing trough ASA(lets say outside to inside ) should drop if password "password" is used . is there any way we can do it trough MPF, if it let me know the configration

Hi, I am trying to get my ASA 5505 to run IP SLA tests in my network management software.  This requires the firewall to support CiscoRTTMonApp.  Does this device have a MIB that will support this? Thanks 

I'm looking at the recent Cisco Advisory and it indicates moving to 8.4 to fix the issues. What would be the highest code level that I would be able to go to?http://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20141008-asaTh...

ASA 5585-x10, ver 9.1I have about 10 public subnets that will be used for NAT translation on the ouside interface.  These subnets are different from the subnet the outside interface.Is there a way to advertise these routes using OSPF from the ASA?  ...

Hi All How do I install the IPS licence on my ASA 5525?Also when doing the initial setup, I believe you session into it, once the ip address has been applied, do you connect via the mgnt port ? cheers  

I have been looking into the Cisco NGFW IPS and CX for Internet threat detection and prevention. What i cannot wrap my head around is that the CX seems to be as much as an IPS as the regular IPS module, but it is not nearly as up to date with the sig...

I have 13 sites each with an ASA 5505 and a Cisco 1602i directly connected to ethernet 0/7 via short 3 foot cable that came with the AP.At 3 of these sites, I have an issue where one or both PoE ports go out randomly. Sometimes uptime will be a week,...

Hi,I have implemented zbfw on Cisco 1800 series router. But after the implementation I could see that Gmail/Yahoo is not loading.Please could some one look into my config and advise. I can access all other websites without any issues.class-map type i...

 Hello All,I have a Cisco ASA 5545 connected to my ISP Router,also i have three servers on which i want bidirectional traffic to pass through the ASA.I want to assign private addresses to these three servers but in different range.Kindly let me know ...