Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi All,I'm newbie on the firewall policy configuration. As far as I know, the policy configuration always need to allow both ways. Exm allows services Port1 --> Port2, Port2 --> Port1 in order for both to communication. I've noticed the policy on the...

wayne loh by • Level 2
  • 527 Views
  • 1 replies
  • 0 Helpful votes

helow guys ,i have many problem with ASA5505 version 91- I save factory default configuration  (write memory )after command " config factory default " but when i make reload i found no configuration saved . my question from where i know the device bo...

Resolved! ASA SNMP

Hi All, Can anyone please advise which of the traps I need to enable if I only need to know fan status. We are running on old version and our aim is to enable snmp traps so as to know if the fan is faulty. Can anyone please advise of the below which ...

Hello,I could really use some help in setting up a port forward rule on my ASA. I have a host on the LAN (192.168.1.24) I need to expose ports 8082 and 8083 (both tcp and udp) to the Internet. I have an existing rule set up for another host on the LA...

Rob Royse by • Community Member
  • 1030 Views
  • 3 replies
  • 0 Helpful votes

Hi, I have this situation:A client of mine has a switched network. On that network where no vlan is configured, he has multiple IP address on the same vlan (vlan 1). So, I´ve installed a 5505 with two vlans, and asigned each vlan to ethernet interfac...

Review Cisco Networking for a $25 gift card