Buy or Renew
Buy or Renew

Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Join

 
Labels

Forum Posts

Start a conversation

Resolved! ASA copy tftp run question

Hello,I have 2 ASA 5520's.  I had to split them up to migrate over to a new ISP while keeping the old ISP in service temporarily.  I want to join them back together now with the new ISP because we are going to be ending our contract with the old ISP....

HeartBleed Vulnerability

With the release of the Heartbleed vulnerability I have been struggling to discover what version of the OpenSSL libraries Cisco uses in their product.  We should start a discussion for devices and software that may be susceptible to the HeartBleed ex...

steinkamp by • Level 1
  • 635 Views
  • 1 replies
  • 0 Helpful votes

ASDM Logs

Hello,ASDM was working perfect, sudeenly now i am not able to see source port, destination ip, destination port, as per the attached, asdm image disk0:/asdm-635.binsuggestion please. Thanks

Resolved! No output for show sip in ASA5515?

Hi,  At the firewall ASA5515 I see that sip packets are being inspected but the 'show sip' command gives 0 output.Below is the output Result of the command: "show service-policy inspect sip"Global policy:  Service-policy: global_policy    Class-map: ...

ISE 1.2 customizing guestportal

We are using the ISE 1.2 for a classic wireless guest management solution. all works fine. now we want to customize the guestportal. At that point we are running into an issue. According to the ISE Config Guide we generated the html files: aup.html, ...

escswosp by • Level 1
  • 1543 Views
  • 5 replies
  • 0 Helpful votes

Resolved! pix nat problem

Hi Guysive created a policy nat on a pix 515E.Im trying to nat a group of ip's from the outside to a pat on the inside.I can see packets hitting a capture on the outside but nothing on an inside capture.As an example I want 10.1.1.1 to go through fro...

mickyq by • Level 1
  • 630 Views
  • 2 replies
  • 0 Helpful votes

Resolved! ASA multiple context pre routing

Hello, I am trying to understand all of my options for routing to two different ASA's in active/active mode, which requires multiple context mode. I have an existing 4500E switch behind a single ASA 5520 right now, and the default gateway that the 45...

Can I create custom OID extensions or import new MIBs to my Cisco IOS router?

I have routers with the c7200-ik9s-mz.124-25c.bin image. I would like to expose firewall rules via an OID, but it didn't seem like there were any pre-installed MIBs which exposed that information. Would it be possible to import a new MIB (IP-ACCESS-L...

Load more
Review Cisco Networking for a $25 gift card