Network Security

Hi,I have been troubleshooting this intermittent issue with Cisco TAC for about 3 weeks now.The issue is that when users connect to external servers via ssh whether it is over a VPN or not, the connections hang. The timing is random and is not depend...

We have a network that has an interface on our ASA.  This network will be moving to a new location and will now be connected to one of our regular layer 3 switches.  What needs to be done on the ASA to disable this network and allow the correct route...

Weird question but does anyone know if the MAC addresses on an ASA5505 is on the label on the box anywhere?  I am pretty sure the serial number is there.  I have an ISP that needs the MAC address and the device has already been shipped to non-techies...

What do I need to do on the ASA 5520 to be able to use a wildcard SSL cert?  I'm running 8.2.5 code.

Hi,I have a 4240 ips sensor on version 7.1(7)e4. When I authenticate to the https interface and select run IDM. The IDM runs and after authenticating a second time I get nothing. I am running the supported version of Java on my client machine which i...

Hi Experts,I am configuring new IPS 5585-x module along with ASA 5585-X module. In the IPS module only one logical interface is showing as per the standard architecture and all the physical interface are showing in the ASA module as 1/X interface(mod...

Hi Team,Need to know in multi vlan scenerio from the inside segment can i able to configure IPS module using ASA 5585-x-10 in transperant mode.Please suggest.Regards,Amit Marathe

I just replaced a Netscreen firewall with an ASA 5515-X.  Everything works, almost!  The Netscreen allowed clients on the guest network to access NATed hosts on the DMZ and inside interfaces, with their Internet addresses. There was nothing special a...

I have the following configuration in my FW--of interest is the classmap Voicetraffic and the policyMap VoicePolicyI do not see the policy map "VoicePolicy" applied anwhere in the FW...so is there actual Qos Happening?or is these global commandsclass...

we have a cisco asa5510 and I have firewall rules setup to allow all traffic incoming and outgoing from the pitney bowes device, I have forwarded ports required all except 443 as it is used by the SDM to access the firewall for management.    Stil th...

Hi all,I need to setup a network enviroment, I have the following equipment: ASA 5512-X & 2960-S Series 48-PortCouple of questions.See the 4 networks below I want to setup as an example.Can I set these 4 networks as seperate VLANs from a single Inter...

Hello,I have configured 2x ASA 5512X in failover mode. My problem is that I cannot access ASA (ping,ssh,asdm - nothing) via any other vlan except INSIDE.For example, from vlan named "VLAN" (10.1.3.0/24) I can access any device from "INSIDE" (10.1.1.0...

Hello,is there way to migrate a feature from one ASA to another one? In fact my old ASA with SEC PLUS got damaged and now I want to move the SEC PLUS feature to the new one. Is this possible?GreetingsMartin