Network Security

Can anyone please help on this? I am trying to enable policy on ASA in order to redirect traffic from a computer to cx for enabling restricted internet browsing/url filtering on that computer. But as soon as I enable the rule, the Intenret on that co...

Hello,I have just bought an ASA 5505 for my home.  Currently I have just a WiFi router from the ISP (Virgin Broadband Fibre), but I aim to put this into modem mode and put onto the outside of the ASA.Once I have done that I need to enable WiFi again,...

Hi,I have following problem after upgrading a ASA5505 from asa9.1.2/asdm7.1.3 to asa9.1.3/asdm7.1.4.When I launch ASDM after upgrading and login with my credentials asdm keeps prompting for a password and dont let me in.I have testet a few tasks but ...

HI All,I have cisco asa 5520 firewall where currently I am running 8.2.5 IOSI need to upgrade the same to 9.0Can any one let me know what is the best procedure for doing the same

All,I hope you are well and can pls assist with my following requestWe have an IPS4255 installed in our data centre and want to cature traffic from all PCI related servers we are planning to use all 4 interfaces on the IPS all interfaces will connect...

Hi,what is the best practice to protect the WAN Interface (Dialer Interface) on ISR Router from common attacks or ip spoofing. I read about creating an ACL to include all internal ip ranges but want to get your feedback on what is best to do. Also wi...

I have a working site-to-site IPsec VPN (created with the ASDM wizard), where the remote hosts come into our network through the range 172.16.203.0/24, and they can access some hosts in our local DMZ at addresses 172.168.1.74.But, I don't have a good...

I have ASA 5520 running 8.3.2 with the following interfaces. All that I need is the best practice so that host in each network can communicate to other networks vise-versa. I want the networks to communicate bidirectional to each other. And the users...

The ASA ran an upgrade of the config. I ended up with a few things I am not understanding.object network obj_any subnet 0.0.0.0 0.0.0.0object network obj_any-01 subnet 0.0.0.0 0.0.0.0object network obj-0.0.0.0 host 0.0.0.0object network obj_any-02 su...

guys:ASA firewall ios version 9.0 pc1--(inside)-----ASA-----(outside)----pc2i want  pc1 and pc2  can  ping  each  each other, and  can   Visit each other .if  like a router, do not use nat .   how can i do ??If you can give me some configurationthank...

    Good Day guys, Looking for a recommendation to secure imap via asa 5510.  Currently running exchange 2003. Any assistance would be greatly appreciated.

I have a small environment that I wanted some redundancy in. It consists of two layer 3 switches that are connected with each other and they both connect to an ASA 5505, forming a triangle in logical architecture. EIGRP is running between all of them...

Hello guys,Could someone from you help me to implement the configuration i have on a  soho 91 router to ASA 5505. I will remove 10.10.10.1/24 from my inside network since as far as i am  concern it was only implemented like this for security reasons....