Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi all,I have some issues about IPS-4260 appliance with management. I used Cisco IPS Event Viewer 5.2 but no activity was shown to it and i cannot browse to IPS box through Https. i tried to reload box but issues still occured.Please give me an idea ...

Hi,I have one question. I have 2 asa's. Standby has now new IOS. When I force on active ASA command #no failover active, primary active ASA become secondary active, but NOT standby ready as I expect. Any idea please?

HiI am getting " Unable to launch device manager from x.x.x.x" I was able to access it previously but not sure what has gone wrongASA5525xSystem image file is "disk0:/asa911-4-smp-k8.binasdm image disk0:/asdm-712.binshow sslAccept connections using S...

Hello, i have small router 2911 connected the main internet router GSR this GSR has peering with ISPs , there is default route on 2911 send to GSR and all user connect on 2911 will go from 2911 to GSR, i had attack ddos attack on 2911 my question how...

Steev112 by Level 5
  • 22082 Views
  • 4 replies
  • 0 Helpful votes

Hello all,I have a small issue for a customer.  We upgraded their old IOS router to a new ASA 5505 with the install of a new MetroE circuit.  They have a SIP VoIP trunk to the telco coming in on vlan20.There has been a increase in their network traff...

pbrunnen by Community Member
  • 1918 Views
  • 3 replies
  • 0 Helpful votes

Resolved! URGENT-NAT PROBLEM

Hi, I have a client with the diagram below, we beleave having a missconfiguration in NAT. Because:Inside computers 192.168.15.0/24,192.168.115.0/24  can´t access outside networks. But can acess webserver on DMZ.Outside networks acess DMZ and inside c...

Hello,I'm setting up a CSC card and seem to have every thing in place.  The card has a good connection to both the Domian control agent and Domain control server.    However when I attempt to create a policy I get no LDAP users/groups listed.I've bee...

rrednet by Frequent Visitor
  • 1655 Views
  • 2 replies
  • 0 Helpful votes

Hi,I created simple PIX,inside,outside and dmz.....my inside to outside connection working just fine...outside to inside also work fine ...but outside to dmz not workingglobal (outside) 1 110.110.110.200-110.110.110.253global (outside) 2 110.110.110....

Hi All,Faced some kind of strange problem when setting up VPN tunnle between cisco routers & Juniper ISG firewall.Problem what we faced is , VPN tunnel came up in phase-1 & phase-2 also and we were able to to icmp & telnet test as well.however when u...

Setting  up asa5510 - i have six interfaces.  Had planned on putting them all at the same secuirty level and then using ACL;s to allow specific traffic.  However I haven;t been able to get any traffic through any ports even with permit ip any to any ...

jschweng by Level 4
  • 2312 Views
  • 6 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card