Hi,Will the IPS go offline during a global correlation update? We are running sensor version 7.1.(7)E4 and are noticing drops due to the IPS being unavailable. The timing of theses matches global correlation updates on the IPS.
Hi,Will the IPS go offline during a global correlation update? We are running sensor version 7.1.(7)E4 and are noticing drops due to the IPS being unavailable. The timing of theses matches global correlation updates on the IPS.
6.3 8.3Good day, Im in a little bit of a twine. I was trying some configs to allow public access to private nodes and my remote side can no longer ping.. Please helpResult of the command: "SHOW RUN": Saved:ASA Version 8.3(1) !hostname ciscoasa-stxdom...
Hi all,Please help as this one server not able to surf internet (80) although it able to establish a site to site vpn with other office. I seem that all config is right but I might miss out something...I post the config below ( i delete most of the o...
I need some configuration assistance with an ASA running 8.4. I need to open ports for a video conferencing service. They have requested that we open the following ports for the IP address ranges I listed. How would I configure this?Video Conferencin...
Hi,I have recently configured Cisco asa version 9.1 firewall with multiple vlans, everything is working but excerpt I couldn't ping the gateway of other vlan from ASA firewall itself (using other vlan interface to ping another vlan interface - all sa...
Our ASA is running 8.0 code. In the ADSM, nat-control was inadvertantly turned off. We will be turning nat-control back on in a future maintenance window. Do the configured NAT rules still influence packet flow in this condition? In other words, ...
We are haing ASA SSM 40 module NIPS at perimeter network. When I keep the IPS in promiscuous mode then eveything is workign fine and when i had configured the same module in inline mode then i am not able to take putty or telnet of the internet rou...
I am totally new for ASA line.we add Shoretel phone system in network, security office has restricted us to install it in existing network, so I create new vlan 30 on sub interface. I can't access any phone from internal network and phone are not ab...
I added a NAT exemption for a server in my DMZ for a subnet Elm and Roc nat (Inside,Any) source static Elm Roc Elm Roc destination static DMZ-Sever DMZ-ServerAbout 20 minutes after adding this rule to my Firewall, clients in the Elm Subnet were disc...
Dear experts, May I ask for your help in enabling failover between two fwsm in 6509 vss setup. When i checked the output of the " show failover" command I am seeing "Version: Ours 4.1(9), Mate Unknown" and the configuration from the primary unit is n...
My name is Victor.I need your help to make my understanding clear about new Cisco ASA 5515-x, 5525-x.I know that this device supports IPS which is included to this appliance without any additional modules.But can this box support IPS and content-file...
Hi All.Have seen a similar issue but am not sure how to approach the problem given my setup.The specific issue is that when any of the following occurs:1) remote users connect/authenticate to the mail server over smtp2) an internal app server relays ...
Hi i am facing issues in my network i have a 880 router with an image c880data-universalk9-mz.153-2.T1.bin.As soon as my EZVPN connects to my HO internet disconnects from the branch. wheni remove a command from dialer 0 no crypto ipsec client ezvpn...
Good day all, I have two two DNS addresses of 10.50.10.21 amd 10.50.10.22. Domain name IT.corp My firewall ASA is issuing out the DHCP address to the client computers I have a network shared on IT-SVR4\finance. 10.50.10.21 i...
I just got ASA 5520 with 8.4.3 and I have copied 8.2.5 and changed the boot system and erased all start-up configs, but still i am receiving below commands, how to remove those context configs and make it single firewall?ciscoasa(config)# boot ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 12-08-2025 06:44 PM | ||
| 12-05-2025 12:44 AM | ||
| 11-13-2025 12:52 PM | ||
| 11-03-2025 09:48 AM | ||
| 10-30-2025 12:44 PM |
| User | Count |
|---|---|
| 4 | |
| 4 | |
| 3 | |
| 2 | |
| 2 |