Network Security

Hi folks,When will IPS 7.1 be supported on platforms other than the ASA 5585 or the IPS 4270-20?  ThanksNeil

Do most configure IPS inspection or code a rule to bypass IPSec inspection. From my testing, inspection causes mis-ordered frames which decreases throughput. If there are several layers of IPS this may compound the mis-ordering.I would appreciate any...

I have two 5520s in a failover configuration. When browsing the internet behind them the speeds average 0.5Mb/1.0Mb Download/Upload. When bypassing the ASAs the speeds increase to 4Mb/6Mb. I have checked the interfaces on the ASAs and there are no er...

Hello,I'm trying to limit one of my inside hosts, since it's been a little of a hog. I have 3Mb available from my ISP via 2x T1. I'm testing this on a computer in a lab:PC 10.10.10.10------Cisco2960-------- 10.10.10.1 Inside - ASA - Outside 208.66.x....

We are upgrading from a Pix 515e to a ASA 5510 with CSC SSM.  We cannot send outbound email or receive any email from the outside world. I have placed a call with Cisco Support with no luck. Here is a copy of my config:  Any Help would be appreciated...

Hi, where can I verify the nature of botnet malware-sites informations ?I'd like to detail the output of "show dynamic report top malware-sites" and I'm looking for a site where I can insert the IP (i.e. 209.53.113.221) and obtain detail, like malwar...

Dear All ,I have 2 ASA firewalls (ASA 5510 Security Plus license.) running in Active/Standby mode and I wanted to add IPS /IDS module on the existing one Which part number will be needed ?  ASA-SSM-AIP-10-K9 will do the job ? or security plus needed ...

We have a nme-ips-k9 module installed in a 3825 router. Is it normal to have a significant cpu usage increase (from 20% to 75%) when we activate the monitoring on one interface of the router with ids-service-module monitoring command ? The module is ...

We have a ASA up for a few years now and I am finally trying to understand some of the syslog info.  I configured it yesterday to email any Alerts and Emergency messages.  In the past 21 hrs I have received 511 (I'm glad I had conversation view enabl...

I have a one-to-one NAT configured (mail <-> xenon), however, I am unable to configure ICMP to respond on the external IP of the NAT.  Below is my config, there is extra ICMP cruft that I have been trying that is probably not necessary, but any help ...