Hello, I have two Firepower 1010 appliances with FTD, one is brand new and the other one is already configured and managed by FMC. The new firewall should be managed localy with FDM and use the exact same configuration. I wonder if there's any way ...
Hi, Is it possible to block or lock any changes when an admin A is making changes, while an admin B wants to make changes also to that same part of the configuration?
Hi,I have a python script that loops through each access policy rules and attempt to disable the rules that match a certain condition. I have the loop and condition logic working but I am struggling with disabling a rule.Here is my python 3 disable r...
Hi to all, we have a working ISE environment with licensed TACACS services.User that access network devices are successfully authenticated as well as authorized. Tacacs live logs show correctly user being authenticated as well as being authorized.A...
Hi, the FTD software (6.2.3.10) on ASA 5506-X does not seem to support point-to-point (/31) ipv4 subnets. When trying to set my static /31 public ip on the outside interface in FDM the error message "You cannot assign a broadcast address as the IP ad...
Hello everybody,our customer performed a FMC upgrade from 7.0.5 to 7.0.6.Since that upgrade Office365 applikations Teams and SharePoint was not recognizedanymore and the traffic was blocket (see screen dump attached) on FTDs running rel. 7.0.5. All o...
I keep getting a failed deployment the only error I see is this.ET-DFW-FP-02 >> error :sysopt noproxyarp Vlan300^ERROR: % Invalid input detected at '^' marker.Config Error -- sysopt noproxyarp Vlan300It refers to a Flex Object that is not needed but ...
Hi Team,We are facing the issue between Ipsec tunnel between 2 sites, tunnels went down frequently everyday after 1-2 hours. Site A has : ASA5516 Site B has : FTD 1120.issue: both the phases shows down, once I regenerated the traffic from site B then...
HI All,Disable an email alerts going to policies--action-alerts, but still getting an alot of alerts. Can someone guide me if anything i have missed.Firepower version 7.0
Hi folks, I hope someone can help me. I need to change the ip addresses on management interfaces of two FTDs, but I do not have access via console.I already tried to configure ssh access via one of the data interfaces but I can't get it working. Is t...
Hello, So i'm doing an assignment and i'm interested in doing a routing setup with OSPF on my Layer 3 switches.I would want to have my layer 3 switches route all the traffic that's supposed to go outside to the closest firewall interface.However i am...
Hello,When I perform a speed test I am only getting 9.46Mbps upload when plugged into the firewall. I have tried plugging my computer directly to the providers equipment and I get the expected 500+mbps upload. The ASA has been factory reset with comp...
Can anyone help me with the below error: init id s1 respawning too fast disabled for 5 minutes We installed FMCv in our Nutanix infra and when we tried to "Turn ON" it throw me the above error, kindly check and help us with the solutions.
I have a Cisco Firepower 3110 FTD and discovered some strange traffic while troubleshooting another problem. The Firepower is making DNS PTR queries to Umbrella/OpenDNS from IP addresses outside the configured /23 on the outside interface. I have ver...
Hey guys,I have a client that has deployed Cisco Firework 1120 in its environment. We're implementing a SaaS solution in their environment, which must have incoming traffic released by the FQDN. There's a limitation because it works with packet filte...
