Network Security

I currently have two networks defined on different interfaces of my ASA 5510 on v8.3.  interface Ethernet0/1nameif insidesecurity-level 100ip address 10.100.1.250 255.255.255.0 !interface Ethernet0/2nameif inside1security-level 100ip address 10.100.2...

Dear SirsWe would like to configure some internet access route through remote site ISP gateway by using IPSec VPN tunnel. For the rest internet traffic keep using local ISP? Would you please teach me how to configure it?Hugo

Just fired up the botnet filter service on one of my ASA's today.  Seeing traffic that is tripping syslog message 338001 and 338002 where the recommended action is to use the dynamic-filter drop blacklist command.When I try to use this command, I get...

Hi,I am trying to find the best url filtering solution for our network.We have a ASA5520 with an ASA-SSM-10 module connected to a 30mb DIA. We are trying to cut access to a number of web sites.The experience I've had in the past when enabled the url ...

We just switched to a 5510 from a PIX 515 last evening, and the only things that are not working are any services from the outside to the inside.  Example: I am unable to connect to a RDP server on the inside from the outside.  I've been looking at t...

I was advised to repost this subject here, so giving it a try:Hello!Although I've seen similar discussions, I'd like to request help in my particular scenario.We have a data center with servers set up for different projects, some servers from partner...

Greatings!Gyes, we had such kind of issue: while installing 2 SSM-4GE modules to 2 ASA 5540 (Active/Standby) the firewall is splitted. That's my step:1) Turn off standby ASA and plug SSM-4GE module2) Power it OnAfter it was booted up failover relatio...

Hello. Running ACS SE 5.1 with 5-1-0-44-6 patch and have following alerts every 2 hours:Cisco secure ACS - Alarm NotificationServerity: CriticalAlarm name: System Alarm [Collector]Cause/Trigger: Store failure (xxx, SystemStatus)I'm storing backups to...

Hi My configuration is as follows ISP1 (primary)                           ISP2 (backup)Cisco 800 series                     Cisco 800 series          |                                             |          |___________      ________ |              ...

Dear bossPlease see my attachment.I want to do static NAT  203.88.148.85 ->172.29.1.5 and 192.168.0.241->172.29.1.5That means all outsider will get mail server by 203.88.148.85 and local user will get mail server by 192.168.0.241.For that i did : rou...

Hi, hopefully a quick question on the use of a pair of ASA 5585's in active/active mode with a shared outside interface.Last time I did this was with FWSM, there was a restriction where all contexts that share an outside interface have to be in the s...

Hi guys.Need little help here with Failover, i have configured Failover Active/Standby and it was running few months but now its not working. and when i try to debug it its giving me these messages.vpnfol_thread_timer: HA MSG: no Buffer available for...