Network Security

Hi,I have been trying to get DHCP realy in a ASA runing 7.2(1) working with no luck.  I added the following the commands to the ASA:dhcprelay server x.x.x.x insidedhcprelay enable wifiSo I'm trying to pass the dhcp requests from the wifi interface (s...

Hi,I have inherited support of some IDSM-II line cards from a previous service provider.  I do not have details of the service account password!Is there any way to reset the service account password?Many thanksLiam

Has any one come up with a neat way of creating a Network Group of public IP addresses.I have branch offices that currently have the ruleAllow from: Inside to:any service:httpTo allow users to browse the web.But this gives them access to some of the ...

Hi to ye all,Please can anyone tell me what to do to obtain a temporary IPS license key? And who is eligible to obtain one such key.Thanks for your prompt reply

Dear All,We are using ASA5500 firewall as a gateway. The company's website is browsed from outside network, but i cannot browse it from the inside network. The webserver is hosted outside the network. There is no access list configured to deny access...

Hi dears.i have 3 switches and 2 ips. stp configurate at switches. sw3 is root sw2 secondary root sw:spanning-tree mode rapid-pvstspanning-tree vlan 50 ,60 root primarysecondary sw:spanning-tree mode rapid-pvstspanning-tree vlan 50 ,60 root secondary...

Can someone describe to me how you would configure a VPN tunnel on a remote peer that connects to an ASA that has route tracking enabled. How would you configure the tunnel when the peer address could be one of two different addresses? Thank you!!Sen...

Launch BIOS Extension to setup ROMMONCisco Systems ROMMON Version (1.0(11)5) #0: Thu Aug 28 15:23:50 PDT 2008Platform ASA5520Use BREAK or ESC to interrupt boot.Use SPACE to begin boot immediately.Boot interrupted.                               Manage...

I have a request for blocking urls using a class map. I have made this work with HTTP, however it does not work for https. This is a 2851 router with IOS Version 12.4(15)T7. I see i could use the command "match protocol secure-https" however this doe...

Hello,I'm replacing a new ASA 5505 due to a corrupted flash.  On the original unit, I had the ability to SSH into the device using TeraTerm with no problems.While configuring the new device, I entered the following commands to enable SSH into the uni...

Hi,One of my client is trying to setup ACL  using FQDN instead of using ip addresses, like permiting specific abc.com on port 999. Is it posible to do that on ASA ( version 8.0), if it is possible then how to do that?Thanks

Hello all, I have a question about Nat. I have configure a pool of IPs to be mapped on a public IP.i.e Range 10.1.1.2 - 10.1.1.5 to 91.200.21.xso that all requests coming to that public IP will be redirected to the internal IPs.object network Exchang...

I'm having problems understanding how to allow access from a DMZ interface to an internal interface.We have:DMZ |ASA > switch > ASA -- InsideThe DMZ is 172.16.10.12Inside is 10.10.1.6How can I allow 172.16.10.12 access to communicate to 10.10.1.6?The...

Can anyone help me with setting up an ASA 5505 to be used as a firewall between a BT internet router(BTNet service) and a Cisco 3560 Lan switch. BT have presented me with a cisco 3800 series router with the following details:Network Address     Netwo...