Network Security

Hi,I want to know if is possible configure VPN Site to Site within LAN between two ASA using two differents subnets without use WAN link neither internet and if is possible how can I configure it?Thanks for your helpAna Maria

Im runing Cisco NAC Guest server Version: 2.0.2. For unnkwown reasons, when I create a guest and set the start and end time ( see atatched file) i get " The account duration is too long". Even though I set the start and end time to 1 minute, i still ...

Hi,Network scenariosite 1 ----->administrator------->Lan--------------->Wan Router----------------------------------------------------->Site 2---Wan Router---------->ASA5500--------->Lan -----------Users.administrator wants  to manage ASA 5500 using ...

Dear all,we have two Cisco ASA 5510 in failover configuration.We tried to change the public IP address on the Outside interface of the primary device but it didn't works. The new IP is not reachable from Internet nor pingable from device on the same ...

appreciate for any assistance..i'm unable to have any internet connection for my new setup.here's the overview.Current setup isInternet -> Router -> PIX 501 -> Switch -> clientsInternet -> static ip given is 210.193.34.1 - 210.193.34.6Router -> Stati...

Hi,I was wondering if anyone knew what the support for WCCP on a FWSM running 4.0(7) is like, if there is any at all ?I've read that the earliest PIX release that supports WCCP was 7.2(1) but I'm not sure how FWSM 4.0(7) aligns with the PIX versions....

I need some help here...I have setup my router with a loopback that's not routed and matched the loopback with the IPS ie"interface IDS-Sensor2/0 ip unnumbered Loopback2 service-module fail-open"I can access the IPS using the "service-module IDS-Sens...

I am facing an issue with SMT mail relay packet which sent from user zone . MY IPS 4240 K9 installed between the DMZ and Internal Zone and the Mail relay installed in DMZ zone. I am able to send traffic from DMZ mail relay server and i am not able to...

Dear Support-Team,I configured Remote Access VPN in 8.3 version.My inside users are 192.168.2.0/24Remote Pool : 10.10.10.1 to 10.10.10.10I configured identity NAT as :object network obj-192.168.2.0subnet 192.168.2.0 255.255.255.0object network remote...

Hi,I want to know where I can check the full feature list for some sub-pacakges just like I am looking for FLASR1-FW-RTU & FLASR1-IPSEC-RTU(=) nowthx!

Hi,I've been tasked with cleaning up some old client configurations. Several have ospf cost statements, but no ospf process is enabledinterface Vlan1 nameif inside security-level 100 ip address 192.a.b.c 255.255.255.0 ospf cost 10!interface Vlan2 na...

Hello Everyone,I am currently having an issue accessing a network through my firewall.  I have access-list that allow this particular network in and access-list that allow me to this network(inside out).  I have checked my acl's, static routes, rever...