Network Security

I have a requirement to implement ACLs on Inbound Ports to block and allow specific TCP, UDP, & ICMP services and to block and allow specific IP address ranges and hosts.  It appears that the most efficient way to d this without having the ACL become...

Hi all,My ssh on my cisco asa 5510 fail to work.I have enabled the following but my ssh client fail to connect to the firewall from my office network(connected to firewall inside interface).aaa authentication ssh console LOCALssh 10.0.0.0 255.0.0.0 i...

Hi,We are using asa5520 with 8.2 version,By mistaklley we have enterd command as ' configure factory default' command in global config mode.it got erased and after rebooting, it's not boting. asn also showing 'invalid key: 0032' on termminal windowPl...

Hi AllI have to suggest a security solution to one of my customer who is having 40 branches within city connected thru RF Customer is looking a solution whenever any branch employee login on the site they receive a password on mobile phone or if not ...

Hello all,Currently i am having ASA 5505. i am having 2 ISP links. I used SLA Monitoring & Tracking for failover of ISP. Means if ISP 1 gose down Traffic shifted to ISP 2.My Qusetion is  Can i use  this same config i.e FAILOVER (SLA Monitoring)  for ...

Hi All,I have  a asa in my company using OS 7 and upgraded to version 8, after reboot that a lot commands are not on the conf anymore, as I saw on cisco web site a lot commands used on version are no longer supported on version 8.Most of things I cou...

Dear all NetPro gurus,I have a WAN scenario with the following scenario:-Site A (192.168.9.23) ----- WAN ----- Site B (192.168.38.41)This is what happens:-At the beginning of day, doesn't matter what the user did at Site B (192.168.38.41), he can't p...

Hi,I'm wondering if this is possible : I seem to remember reading somewhere that it is, but do you think I can find the article?(please see attached NET01.JPG file)I have an ASA5510 with a few servers sitting behind it and some users that authenticat...

Hi,I  have  a  problem  with  a  FWSM,  Version 3.1,  when  I  try to  execute  the  command: FWSM(config)# resource acl-partition 3% Unrecognized commandor  when  I  type:FWSM(config)# resour?% Unrecognized commandfor  resize  memory  partitions.---...

I'm trying to release a default route learned via OSPF  into EIGRP in an ASA running version 8.2.2. my config isrouter eigrp 1redist ospf 1 metric 10000 100 100 100 1500 route-map STATICaccess-list DEFAULT permit 0.0.0.0 0.0.0.0route-map STATIC permi...

Hi, which would be the way to do this upgrade, I think maybe something goes wrong with the failover, any suggestions?