Network Security

Hi All,I have  a asa in my company using OS 7 and upgraded to version 8, after reboot that a lot commands are not on the conf anymore, as I saw on cisco web site a lot commands used on version are no longer supported on version 8.Most of things I cou...

Dear all NetPro gurus,I have a WAN scenario with the following scenario:-Site A (192.168.9.23) ----- WAN ----- Site B (192.168.38.41)This is what happens:-At the beginning of day, doesn't matter what the user did at Site B (192.168.38.41), he can't p...

Hi,I'm wondering if this is possible : I seem to remember reading somewhere that it is, but do you think I can find the article?(please see attached NET01.JPG file)I have an ASA5510 with a few servers sitting behind it and some users that authenticat...

Hi,I  have  a  problem  with  a  FWSM,  Version 3.1,  when  I  try to  execute  the  command: FWSM(config)# resource acl-partition 3% Unrecognized commandor  when  I  type:FWSM(config)# resour?% Unrecognized commandfor  resize  memory  partitions.---...

I'm trying to release a default route learned via OSPF  into EIGRP in an ASA running version 8.2.2. my config isrouter eigrp 1redist ospf 1 metric 10000 100 100 100 1500 route-map STATICaccess-list DEFAULT permit 0.0.0.0 0.0.0.0route-map STATIC permi...

Hi, which would be the way to do this upgrade, I think maybe something goes wrong with the failover, any suggestions?

Hi,i understand that ASA 5520 is coming with default 512MB memory on it. is there an option to upgrdae the memory?, if it can, waht is the maximum memory i can get and what is the part number for it ?thanks,

We would like to be able to generate a trap or some how determine if/when our IPS-4260 sensor goes into bypass mode. In addition, we'd like to be able to monitor the CPU, memory, and interface status.. It would appear the 4260 has limited monitoring ...

We have a vm environment and then a physical switch and a firewallcan't seem to get it to workneed some assistance and I am trying to learn what is going on

Hi guys,One of my assignment is to compare firewall rules and make sure it match with the documentation sent by requestor.Let say this is part of request sent by requestor.source ip address = 192.168.1.1 source ip address = 172.16.1.1 protocol = tcp ...

Hello,I have an ASA5510 for a customer, that no one knows the enabe pass word for. I have gone throught the ASA pass revovery procedures, got into the enable via pass revovery,   typed   enable password XXXXXXXXthen when I do a show run,  I see the e...

HiI am pritty new to the pix config. What I am struggeling with is to get inbound access to my mail server on port 25 from my outside interface ( PPPOE)I also can not get SSH access to the outside interface to my PIX.I have been trying everything I k...

Hello,regarding ASA devices, is there posibility to route (and filter using ACLs) IPv6 multicast traffic?Thanks,K