Network Security

Greetings all,At my workplace I have a Linksys RV082 router. I have setup the VPN using the QuickVPN utility provided by Cisco/Linksys. When I connect from home, every now and then I will get to the verifying network stage, where it will post an erro...

I have recently set up my SSLVPN on my ASA 5510 running ASDM 8.0 (4). I would like to use the CIFS function for VPN Users, but I get an error when I try to click on the server share. I get error connecting to host, eventhough I am able to see the ser...

Hello, hopefully somebody can help me with this problem. I have wireless routers connected to the DMZ. Internet access through the wireless routers are fine from laptops. However, when we try to access or browse the Internet from the iPhone, ASA drop...

In my ASA 8.2.1 ASDM 6.2.1 i see the hitcount for a "deny any any log" log increasing but i can not get the corresponding log entrys. Even marking the ACE and "show log" does not output a single line. Getting the denied packet was only possible using...

I have to implement a Site to Site tunnel with one of our client they have provided me there vpn router ip with configurations and have asked me to connect the vpn using a particular private ip 172.16.16.1, where as my local LAN IP is 192.168.1.0/24....

We have a L3 OOB, workstations are using the CA Agent, both XP and Vista machines. After login the CA Agent keeps looping, refreshing ip successful, the switchport never changes from the untrusted Authentication VLAN to the Access VLAN, the workstati...

Hello there! I'm stuck and need your help please. I have installed NAC Server (ver 4.5(1). I'm deploying OOB VG. I've connected both CAS and CAM on a 6506 Cisco switch. My problem is that i can reach the CAM but cant reach the CAS.Below are some conf...

I have ZVRS Z-340 I am trying to connect to an outside server. I have the policy outbound for the ports the phone needs. If SIP is inspected on the ASA is their anything else I need to enable for STUN?Below are the ports the Vid phone requires outbou...

Hello I want to set up the Above Network to let the outside user connect to the corporate network using VPN client software when they are abroad. Question is, where should I terminate the VPN connection? It's on the internet router or on the ASA? Any...

I have an ASA 5540, running 8.0 software.Interface "IN" (security level 100) has subnet 192.168.1.0/27 directly connectedInterface "OUT" (security level 100) has a route to 192.168.0.0/16.Interface VPN (Security level 50) is for VPN clients to connec...

Hi,I have ASA 5505 firewall. After powering up the device LED's are flashing and going off. What I have to do with this firewall?RegardsSKR

Hi,I am using ASA 5540 and trying to implement LAN Based Active/Standby Failover using Management Interface. It seems that failover is possible but not the Stateful failover. Can anybody confirm me... about it that using Mngt interface I can not do S...

I'm using the ASA for anyconnect users and I keep seeing log messages similar to the following:4 date=Oct 07 2009 Source IP=10.1.1.201 Source Port=17571 Destination IP=10.0.250.18 Destination Port53887 Duplicate TCP SYN from inside:10.1.1.201/17571 t...