Network Security

Hi...I have a 7206 VXR router with advanced ip services image connected via its gig ethernet port to the ASA's outside interface. I can telnet from any pc behind the ASA to any serial interface on the 7206, but I cannot telnet to the gig ethernet int...

Hi, I'd like to upgrade a 525 from 6.3 to 7.0 and but I'm not sure if upgrade in monitor mode is required. The upgrade doc talks about monitor mode for 515 and 535, but it's better to verifythanks

It seems that I can use the default route for both inside and outside network reachability.route inside 0 0 10.x.x.xroute outside 0 0 32.x.x.xIs this the case?

Hi,We have an ASA with the IPS module, how can I ignore signature ID 6402 completely?

I have Cisco ASDM image 6.13 in my ASA 5520 ver.8.0(3). I was able to launch since the day it was installed, but for the past 3 weeks, I see the process bar going & there finally stuck. No error message, i have the proper Java version installed, whic...

Hi,In ASA and Cisco Router i already open the port for the SFTP which is port 22, but user unable authenticate the SFTP service.Is it the port i opened incorrect?pls advisethks -gilbert

Hi With ASA failover in transparent mode, I don't see the mac-address-table replicated from the primary to secondary unit. Any comments...With regardsKings

Hi All,I have configured a site to site VPN with a cisco ASA 5510.I was able to setup the VPN. Phase1 & Phase2 are all up and traffic can pass.What i notice is that from time to time the tunnel goes down and the remote site will have to send a contin...

My internal network is 10.10.10.0/24 which all hosts that access the Internet belong to. I have configured the internal router with WCCPv2 and the IP address is 10.10.10.1/24.I have an Ironport S160 on an ASA DMZ network which is 192.168.10.0/24. I h...

Hello,The latest OS for the iPhone allows users to tether their iPhone to a Mac/PC so that the user can browse the internet through the carriers mobile 3G network. I can confirm that internet tethering works on my Macbook Pro, but the following error...

I have to connect 2 ASA's 5510, one with the IPS module and the other with CSC module. Which is the best way and how do i configure both? Internet-->ASA-IPS-->ASA-CSC-->LANDo somebody know a link with that scenario?Thanks and regards.

We need to bring in our SIP provider through a publicly addressed connetion and need to NAT it on the firewall. But the NAT only changes the source or destination address of the IP packet. How can we also NAT the SIP body messages for INVITE commands...

Can you configure OSPF on the FWSM. VLAN 199 & 200 are configured behind the FWSM and I want them to be routed apart of OSPF 99.Please advise.### 6500 ###interface Vlan100description "MGMT"ip address 10.26.20.1 255.255.255.0interface Vlan199descripti...