Network Security

All,I have an ASA 5505 that I'm trying to get a tunnel up with a 2800 series router. The tunnels get established, but the ASA side is encapsulating and not decapsulating traffic and I'm not able to pass traffic.I have the following:WinXP host (10.125...

Working in a VSS environment, one firewall in each catalyst, configured with two context and Active / Passive scenario. One VLAN exist between two context, but no communication between context over the VLAN. ARP is showing same mac-address on two dif...

Hello Experts,I have been using the time based ACLs for quite a while now. But I never able to figure out, to how many time-ranges we can create on a ASA 5510 and ASA 5520. Is there any limitation to that, to how many time-ranges we can define?Thanks...

Hello how do i export the ASDM syslog message to a file and how far back can I go to get information?

Hi everyoneHad a couple of riverbed devices which were causing lots of SSL malloc errors on the ASA firewalls. Theyve been taken out for now but theres still malloc errors but nowhere near as much. When there were loads of malloc errors Webvpn connec...

with my last post, I got bidirectional nat to work from outside -> inside. Config below:global (inside) 99 10.153.99.1nat (outside) 99 10.148.12.0 255.255.255.0 outsideNow, the problem is getting NAT to work from inside -> outside. This is the error ...

Hi, I've upgraded one IPS (ASA-SSM-20) to release 7 and now I can't see any events on it and obviously MARS doesn't receive any data from IPS. I've tested that virtual sensor is assigned to Gigabit Ehternet 0/1 and Global correlation seems to work ok...

I need some help on how to deploy this setup. The fios internet connection was installed in our data center but the public users are located on the other end of our network. Hence, this connection needs to traverse thru our internal network. I wou...

What could cause this message, shouldn't this part show the subnets I'm connecting via the tunnel. I'm guessing that it is anaccess-list issue"local Proxy Address 0.0.0.0, remote Proxy Address 0.0.0.0"I'm also gettng "Invalid ID info (18)"Thanks for...

I have just replaced a Raptor firewall with a Cisco ASA 5505. On the Raptor, I could specify that all inbound traffic on the outside interface be transformed into a 10.1.2.x address from a pool. What is the equivalent command on a Cisco? I had two...

Has anyone tried configuring the ASA in multiple-context mode.Is the cisco ASA truly able to justify its mulitplicity.what are the issues encountered.

Trying to setup a l2l vpn between 2 ASAs and came across this in the logThanksJun 21 17:07:46 [IKEv1]: Group = 71.172.68.18, IP = 71.172.68.18, IKE Remote Peer configured for crypto map: vpn_mapJun 21 17:07:46 [IKEv1 DEBUG]: Group = 71.172.68.18, IP ...