Network Security

1. How the standby unit will detect failover in following two cases(if the actual primary unit has been powered Off due to some reason 1. If we are using a crossover cable to connect the active and standby units 2. If we are connecting active and sta...

I have this command in my configip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 1but gateway of last resort was not set, and this route is not show when I do "sho route" command.I try remove it and add it again, no luck.Thank you for your help.

Just a heads-up!Hey guys just installed Java 6 update 11 and this breaks ADSM v6.1(1) running on a PIX 515 running 8.0(3). Gives you a unconnected sockets not implemented, and then closes! Just removed it and it'll start working again. I verifed this...

The ASA 5505 comes with a default IP of 192.168.1.1. I need 192.168.10.1. I can change it with Telnet, with https Applet and with https Startup Wizard, but then I am locked out until I go back in with Telnet and put it back to 192.168.1.1.When I Show...

I am looking for method to automate backing up FWSM configuration. Our FWSMs have more than four contexts and I am looking for backing up all of them. Although I have read old posts on this in netpro but couldn't come on some concrete conclusion and ...

Hello,I have the ASA configured and everything is working fine. But whenever I add a static policy nat, it stops my computer to communicate on port 3101 (TCP). When I take it out everything works fine. I would like to translate one local address to m...

Hi all I have got two ISP Connections and With PIX 515 i just want to load balance my outgoing traffic to internet.Does PIX Support load balancing Can we have Two default routes to two Routers in PIX 515?

i hav 2 cisco 877 routers with dynamic ips provided from my isp .i hav created site to site vpn among them with the dynamic ip address but whenever the ip changes i hav to change the shared key's ip address and the tunnel ip address after which it ge...

Hi Guys,there is a small detail i am not getting right. how do you add more vlans to your FWSM after the initial one you do on the switch.e.g firewall vlan-group 1 10,15,20,25firewall module 1 vlan-group 1now i want to add more vlan interfaces to the...

Hi all,I would like to upgrade our ASA 5510 from version 7.2 to version 8.0. Unfortunately, I don't have any spare ASA that I can test the new configuration on. So I'm just going to have to read the docs and fly blind. I don't plan to change the conf...

Hi All,We have recently purchased an AIP-SSM-10 module for our ASA5520. I have installed the module run through the initial configuration and updated the software / signatures to the latest version via the ASDM.I am about to run through the following...

Hi,Can anyone tell me that If I want my user to download clean access agent so how can I achieve that...I have uploaded agent to my CAM but Im confused that should my user use web agent first then download the agent over network or he can download Cl...

Can anyone explains the exact meaning of Perfect Forward Secracy in simple terms and detailed manner