Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Our Client is having 2 ASA firewalls ( 5540 ) along with AIP-SSM modules in it . They are configured for Failover . The OS of ASA is 7 and the OS of IPS is 5.0 . I have read on Cisco website that Password recovery cant be done on IPS modules having 5...

Hopefully someone can help with a termination issue I'm having with a PIX-515e firewall; software version 6.3.4, pdm version 3.0.2.We're getting constant vpn termination errors (reason 412 and 413) from a group of users at one location. I am by no me...

eriklozano by Community Member
  • 1878 Views
  • 9 replies
  • 0 Helpful votes

Can somebody tell me what does drop rate mean in "show traffic" command output? I looked up command reference document but that doesn't have any information. I am running 8.0.4 code. 1 minute input rate 1015 pkts/sec, 1063149 bytes/sec 1 minute outpu...

smunzani by Level 3
  • 592 Views
  • 1 replies
  • 0 Helpful votes

Hi all.I want to limit my network traffic, outbound of my ASA, to a TOTAL of 30 Mbps.I've configured service-policy to do this, but police parameter is applied to single sessions, and not to total traffic.Is there a method to obtain this?ThanksDaniel...

I have an ASA 5510 that has a DMZ configured on it (192.168.0.0/24). The DMZ works fine except VPN users cannot hit any of the websites that run in the DMZ. My DMZ users connect through the Outside interface and are assigned a DHCP address from the p...

qbakies11 by Level 4
  • 2813 Views
  • 15 replies
  • 0 Helpful votes

We have a few site to site VPN connections with 5505's. Is there any way to setup a redundant config incase the first one goes down it would reestablish to a second firewall with a different ISP? I am using 5520's at both ISP's.

jrgates by Level 1
  • 995 Views
  • 3 replies
  • 0 Helpful votes

I want to deploy NAC in my company, I have some questions about NAC: 1. If I deploy 1 NAC server and 1 NAC manager with IN-BAND: - When NAC server dies (NAC manager oprates), traffic is bypass or not? what things will happens? - When NAC manager dies...

mylove142 by Level 3
  • 1600 Views
  • 6 replies
  • 0 Helpful votes

I'm having some troubles setting up a new firewall. (I'm new to firewalls)I've got the unit up with configured IP addresses on inside and outside. Downloaded and installed ASDM software. I can't seem to get it to pass traffic. The unit is being used ...

dklewe by Community Member
  • 756 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Nat-control

Hi,I was reading about Nat-Control.More I read it more confusion.It comes disabled with version 7.0 and more.It is something;When nat-control is enabled NAT is required for all traffic flowing across the security appliance. When nat-control is disabl...

sushil by Level 4
  • 1598 Views
  • 7 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card