Network Security

Hi,Can I paste the pix with software 6.2 configuration directly to Pix with software 8.0...Pix with 6.2 had Remote-Acess and Site-to-site VPN ; is there a way to recover password and keys configured on the Pix so that I could keep as reference.Thanks

hi expert,I want exact meaning of this command1. crypto map xyz local-address Loopback02. crypto map xyz 1 ipsec-isakmpfor 2 command we r defining crypto map, i would like to what happen if i give map with different seq. no, Thanking you,Prashanth

On a daily basis, for as long as my logs go back (over a month), my 1811 router has been flagging %IPS-4-SIGNATURE: Sig:3327 Subsig:1 Sev:5 Windows RPC DCOM Overflow and Subsig:0 multiple times daily from all different external ip addresses on random...

Two recently purchased ASA5520-K9 vere delivered to us with software v7.0(7).We have successfully configured them and finally updated to the latest release of the v7.0.x i.e. v7.0.(8). The ASA5520 with v7.08 are not yet in the PROD environment but th...

If I propose a ASA firewall with content securiy, do I need another firewall for IPS. If so, it will be an expensive solution for my client. What is your recommendation? I am trying to replace a forigate firewall that has content security and IPS. Th...

Hi everyone,i am having trouble stopping ares P2p filesharing software. i have to stop this some how. as you all know it is not listed in the signature list of the cisco ips. i updated the ips signature still no use. so if anyone could suggest me , t...

I permitted https, web and 1433 (SQL) access from the outside to the Enterprise Portal (EP). I can access the EP, but I cannot then get information from the Reports/Analysis box. The system works ok from the inside.

Anyone have any experiences or opinions on running 8.x code on an ASA firewall pair that will have about 80 IPSEC tunnels on it? We have to migrate from our old 3000 series concentrator. The allure of the 8.x code is the ability to debug a single tun...

Hi all,Can you tell me what is a good book about ASA to study?What should you recommend?Thanks

Do not have a Pix at hand to test so I willask with this given scenario:1- What ports must be open on the Pix inorder to allow ftp over SSL to work properly?2- Is it possible to allow ONLY passive FTP through the Pix firewall in this given scenario?T...

Following is a lab topology:I cannot ping from interent(LAB) router to the inside interface of pix as well as lan.ALso cannot ping outside interface of Pix from lan but can ping the system on internet(LAB) .Can anyone help .Thanks in advance. system ...

We just started using the ASA 5510 with the CSC module. We have a development Webserver in DMZ. From within the LAN we see a lot of broken images when accessing web pages on the development web server in the DMZ and Web pages outside our network. The...

Is there anyway to configure an ASA to make it possible for AnyConnect SSL clients to be able to traffic over IPSec tunnels to remote networks. The IPSec tunnels are configured on the outside interface, which is the same interface that the SSL client...

Hello, I need advice on how to setup DMVPN for the following scenario DataCenter#1 DataCenter#2 Branch-Office#1 Branch-Office#2 Branch-Office#3 DC#1 is connected to DC#2 via MPLS using BGP BO#1 is connected to DC#1 with GRE Tunnel over IPSEC (( Routi...