Network Security

Hi All, I have an IPS Sensor 4240 working inline with the default settings... I need to do some tests and I need to change it to behave as an IDS. I know that I should configure the port on the swith as a SPAN port to send all traffic to the IDS (tha...

what is the processes of password recovery on WS-SVC-IDSM-2?I use this module on a catalyst Cisco 6509 serie

Is there a way that I can tell how much throughput I actually need when purchasing an ASA? I have about 5000 users, and it's easy for me to say that I need 1.2gbps, but is there a better way?<br /><br />Thanks!<br />John

I am looking into purchasing some ASAs and found that they are trying to sell them as "editions". IE "Content Security Edition" "IPS Edition" "SSL/IPsec Edition" "Business Edition".Where can I find detailed info on the differences (preferably all in ...

I was using FWSM 3.1(5) with ASDM 5.2(2)F. There, you were able to query the ruleset for sources, destinations etc., even if the sources, destinations were hidden in an object group.Now I've switched to FSWM 3.2(10) which brought ASDM 6.1(2)F. Now th...

Hi,I am trying to telnet and ssh to the asa from the inside routed subnet, then its not happening. but when i do telnet from the directly connected subnet of the asa it works.does its the constraint of asa or anything can be done on this?

Hi,I have many UNIX servers in different DMZs and inside zone. They connect each other by using RPC service ports. Even when i checked server rpcinfo -p the ports getting mapped with rpc service to tcp and udp ports are different in different servers...

Hi, Currently we are running Cisco CSM and Cisco WCS applications on different servers.Please let me know can it possible to install Cisco CSM and Cisco WCS on one server.Regards,

Hello all... I have webVPN setup on an ASA 5520, I can login just fine but when I try to access a URL I automatically get logged out instead of going to the URL I've typed in. Can someone help me out on this? Thanks.

If i already use ACL on router interface and then should i do about the Pre-Block ACL and Post-Block ACL?what router will do the Existing ACL on the Interface?And the name of the ACL used on the router must be in form only?

I have two DMZsDMZ1192.168.1.1security level 10DMZ2 192.168.2.1security level 5If I want the lower level to be able to communicate with the higher level DMZ:static (DMZ1,DMZ2) 192.168.1.0 192.168.1.0 netmask 255.255.255.0 0 0access-group dmz_allowed ...

Hi ,I am using pix515e.I am unable to ping from Inside server to Outside interface but from pix i am able to ping the outside.interface Ethernet0 nameif Outside security-level 0 ip address x.x.x.x 255.255.255.224!interface Ethernet1 nameif Inside sec...

could anyone please tell me whether cisco supports both of these now