Network Security

I have setup redundant ISP connections by using SLA and changing routes. I would like to know when SLA rule fails to ping the ISP. I can't find the oid/mib to get the status of the specific SLA or what trap group I need to configure to get notificati...

MY ASA5505 is blocking the secure traffic to an FTP server. Standard FTP is fine. What am I missing?

Hi. In my office I have a Pix Firewall 525. That equipment had the 6.3 software version and it was updated to 7.2(4) and now I have a problem: When I try to do a Videoconference with a Polycom Camera, is no possible to connect. I've checked the proto...

Hi,We are in the process of migrating some Cisco VPN 3030s to Cisco ASA 5540. I have a couple of questions regarding the subnet mask of the local IP pools defined on the ASA.In the command reference it is mentioned that the packets could be routed in...

This is a bit complicated so let me layout my setup first. I have a 5510 ASA for my firewall. On it I have the following interfaces configured:Outside - x.x.x.xInside - 192.168.200.210DMZ1 - 192.168.0.1This is a list of my routes:Gateway of last reso...

I have made changes to nat and IPSec ACL's but the new lines in the ACL's are being ignored!This results in packets that should be sent encrypted going out unencrypted even though the packets match the ACL.On a different interface new rules for nat a...

I have configured Active / Standby and it working perfectly. I also have configured Stateful failover in the Firewall using the same Interface of Failover Link Gig 0/0. That is I am using the same Interface for both Link Failover and Stateful Failove...

I have a scenario where NAC is to be deployed in a University for staff and students. so i have created two roles Staff and Student. There are 2 AD (Primary and secondary) each for staff and student. Question 1Is that possible to define 2 AD for SSO ...

hi,while migrating from a VPN Concentrator 3000 to ASA 5520 (IOS 8.0.4), we'd like to put all VPN-related configuration settings in an openldap server (2.3.27).We have trouble finding ways to put group settings, LanLists (as they were called on the C...

what if a single ip is both nat 0 and nat 1

Hello ALL, My PIX 515E overheated and caught on fire. I have transferred all my configs from the PIX to a ASA 5505 Except fixup protocol dns maximum-length 512fixup protocol ftp 21fixup protocol h323 h225 1720fixup protocol h323 ras 1718-1719fixup pr...

Hi. I have a problem with VLAN that is in a FWSM. This belongs to Vlan computer rooms that have private address 172.16.0.0 mask 255.255.248.0, the IP addres of the VLAN in the FWSM is 172.16.0.1 - 1 months since I am experiencing the PING between PC'...

Please i need to configure asa5520 as firewall with 2 2 DMZ+ 1 outside + 1 insideI need configuration exemple for the same case : help pleasethanks in advance