Network Security

We have a Corp. network with CUCM 6.1 in the inside network of the ASA connected to the internet We would like to use the wireless ip phone 792x from any public hot-spot to connect & register to the our CUCM 6.1 ( Static NAT is used for the CUCM , bu...

Hi,I currently have an issue with ftp and rdp connections from 2 specific hosts. I have setup acls to allow for ftp and rdp connections from our internal network to these two specific hosts in the dmz. We have 2 ASA 5520 setup in a Active/Standby Con...

I had a post with a 6.3(4) referring to the same issue, so now Ive treid the same with an ASA.My config:int insidesecurity 100ip add 172.20.1.1int outsecurity 0ip add 10.10.10.1int dmz192.168.4.1security 20nat (dmz) 1 192.168.4.0 255.255.255.0global ...

Hi all, I'm just wondering what some of you are blocking outbound on your firewalls.

Hi allI have csc-ssm 10 module . The base and the plus license are expired . Please I need to know the part number to renew the base and the plus license for this module.waiting your repliesregardsMohamed

i have enabled logging & configured clock time zone and set clock maually in pix525 firewall, but when i issue sh logging command logs are not showing the timestamps.please find the commands in my firewall:logging onlogging timestamplogging buffered ...

Is there any limitation for number of VLAN pairs with IDSM-2 module in 6500 to configure in in-line mode ?

Was wondering what the best practice is for this type of setup ??Do I add a deny all on the OUTSIDE interface, or is best to add it to the INSIDE interface ???Any suggestions appreciated.Thanks

Hi, I am using Cisco Anyconnect 2.3.0185 and Asa 8.0(4).IP address are assigned statically by ACS.I specify IETF Rdaius Attibutes 9 (Framed-IP-Netmask) to return the correct mask (255.255.255.255 like a ppp session).But the IP Gateway returned to the...

HI ,I have a ASA 5520 with SSM module installed. Users are facing RDP disconnection in every 10mins while accessing from one nw to another via ASA.Can anybody tell what could be the reason. ASA firmware version is 8.0.3

we have a client with a soho91, they have a workstation trying to make a secure connection using a vpn client. The vendor informed us that the "firewall" need to allow 3 specific ports. There is no access-list applied to the outside. I created a acl ...

I have an ASA 5510 running ASA 7.2 and ASDM 6.04, as of the first of the year it will no longer do any graphics due to it being "unable to read configuration" Is this the correct version now, did it go dark or is there something else wrong. The 7 VPN...

Hi All, i am trying to prepare for exam and i'm bit stuck with this scenario in my lab. Could someone help me with this? I'm trying to nat one outside global ip address and tcp port to two different inside server based on source ip address.I have two...

Hi All,When i try to divert the traffic(http,ftp) to CSC from ASA inside interface ,internet is not working.What would be the Problem?