How can I block Lime wire on my router 2800 I tried build in feature through SDM but limewire still works. I even tried to block port 6346-47. no luck,,,,,,,Please help.
How can I block Lime wire on my router 2800 I tried build in feature through SDM but limewire still works. I even tried to block port 6346-47. no luck,,,,,,,Please help.
How should the physical connectivity of ASA AIP-SSM be in case of inline interface mode inspection for all the firewall interfaces. ?Rgds.
Hi allI'm trying to design a data center security solution. I have a 6509 E with sup 720 and FWSM. My concern now is whether to go for IDSM or a 4200 sensor. I know about the through put limitations of both products. Can you all highlight any other p...
Today, ips-4250-sx (not-in-line) upgraded from v6.0(4)E1 to 6.0(5)E2. (S335) to (S339)1st appearance & flood of red alerts,all internal sources and destinations:1) Windows DCOM Overflow 0&1 subsigs: (1100src/100dst=86k total hits)2) Netware LSASS CIF...
When shunning, how is the interface decided?show shunshun (outside) 1.1.1.1 0.0.0.0 0 0 0shun (inside) 2.2.2.2 0.0.0.0 0 0 0I believe both IP addresses should be shunned on the outside interface.
Has anyone else been running a 4270 sensor in production with traffic at 1Gb/s or more?I'm interested in discovering if the symptoms we're seeing are unique with the default signature policy and 6.0(5)E2:Event Store wrapping every 60-90 seconds, maki...
My customer has an evironment with inline CAS for wireless-users and out-of-band CAS for wired users. The Wireless-controllers and Clean-access users authenticate with RADIUS and MSCHAPv2 to a Microsoft IAS 2003-server. When the users passwords expir...
I was successful in configuring my ASA 5510 to allow on incoming queries on port 80 to 204.xxx.xxx.178 to be redirected to port 8123 and go to the internal IP of 192.168.100.178.I set this up on the ASDM under the NAT Rules section. I used the PAT s...
I have a Pix-535. It was running fine for couple of weeks, until I turned it off and on again. After that, the pix run for 5 to 10 minutes and the begin lock out traffics and console. If I did a reboot on it, it doing the same thing.
I have setup two pix 501 running OS version 6.3(5) with a 10 user license between two offices conencted via DSL. Traffic flows both ways as intended. However, occasionaly I have a problem where I cannot remote onto any machine at the remote office ...
I am currently implementing and testing the NAC Appliance solution for clean access. I have noticed a massive flaw in the security of this product, unless I'm mistaken. I was wondering if anyone can comment on this.In order to utilise Active Directo...
Dear All,I configured the NAC HA for one of our customer. The HA is working well.When i connected the pc to the un-trusted vlan i am getting the auth page where i could get only local DB not getting the AD provider in the drop-down.How can i solve t...
I have an IDSM-2 version 6.1.1 E2 sig 353. The IPS is running in promiscuous mode. The IPS is alarming on impossible IP packets. To trace down the culprit, I decided to log the packet pair with the hopes that the layer 2 information would help gui...
I have a remote site which has low grade switches so i am unable to block devices at the switch level. Is there anything i can do on the ASA 5505 to block a specific mac address from using the internet connection. It's an unknown device connecting to...
How do you configure the outside interface to receive its IP address from a dhcp server? (in this case, from a cable modem)I have a 501 PIX running 6.3.5Also, after you configure the outside interface for dhcp, how do yu configure the route so everyo...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
09-17-2024 06:52 PM | ||
09-12-2024 08:37 PM | ||
08-30-2024 11:35 AM | ||
08-19-2024 03:53 AM | ||
08-14-2024 08:06 AM |
User | Count |
---|---|
8 | |
7 | |
6 | |
5 | |
4 |