Network Security

I am trying to bring up an IPSec tunnel between an ASR1002 and a 2821. The tunnel itself works. Only the 2821 shows hits against its access list. Only the 2821 shows packets being encrypted with no decrypted packets. I purchased the firewall and IPSe...

I have been trying to setup my ASA to block P2P traffic. I followed the guide here http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808c38a6.shtml. When I make this my config I lose all HTTP traffic. I also tried to up...

Hi,I have a ASA 5540 configured in WebVPN to authenticate users through an ACS server. The ACS server can use my Active Directory Users Database.a user with those credentials:login : testuserpass : céli20can login through Remote Access VPN (classic ...

I have a user who once they connect outbound via VPN client to a customer. Can't establish a SSH session to the customer server. When I place them on the outside of the firewall the connection is successfull. I check the config nothing is block going...

Our ASA 5510 has sw ver 8.0(2) and DM ver 6.0(2). Through ASDM on the menu Configuration>Site-to-site VPN>Advanced>IKE parameters under NAT transparency we checked "Enable IPSec over NAT-T" and wrote config to startup and also we did it manually. Aft...

Do I need to upgrade from 2.3 to 3.2 and then 4.0?Or can I directly upgrade to 4.0 and also the asdm file with tftp?And after copying the new software what we need to do is only reload? thx

Hi all,I would like to know if there is any kind of SNMP OID or SNMP TRAP to detect/inform the failover state of a ASA. The idea is to know what is the active/standby ASA in failover configuration.Thx in advance

Attached is my 1841 security router config. Simple question. Device 10.2.1.6 is my e-mail server & I want it staticly routed through the 65.103.52.172 address, such that when it sends outbound mail the recipients mail server sees it coming from 65.10...

I have a main site in USA and a remote site in the UK (w/ 3 users). I have a 5510 in the USA and will be installing a 5505 in the UK. I want to create a site-to-site VPN between the sites and direct all internet traffic from the UK through the 5510 i...

Having a bit of trouble understanding the simplicity of this error message. Browsed around and found nothing specifically related to the issue at hand. I ran the ASDM software and device/user/password box comes up. I type in my user/pass with the dev...

The outside interface on my ASA has been pegged now for about 4 days, just noticed it this morning. How do I find out who is hogging all the bandwidth??

Good morning.For auditing purposes, we need to log which commands where type into the ASA console, with user and time.Could you tell me which is the command? I can't find it... it has change from "Archive".This will also log the commands introduced v...