Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have a ASA set up with two context for active active failover. Before this configuration I use to do packet capture on the ASA and transfer them to my computer with the following command:copy /pcap capture:inside tftp:Since the context configuratio...

gm-douglas by Frequent Visitor
  • 1578 Views
  • 2 replies
  • 0 Helpful votes

What is the easiest way to log what private IP used a Natted public IP at specific window of time. We recently were informed that address 174.103.12.45 (within the scope of our public addresses) was scanning ports on a network. We have an ASDM 5.2 in...

Resolved! tunnel and acl

VPN Parameters site to site vpnpix remote end point is XXX.XXX.80.108pix remote network is 192.168.50.0/24 pix will need to make ACL from 172.24.176.9 to host 192.168.50.83 and 192.168.50.86 pix will need to NAT intresting traffic to 172.24.176.0 /24...

c-drozd by Community Member
  • 1459 Views
  • 5 replies
  • 0 Helpful votes

Hello,I'm trying to configure a asa 5510 to forward the smtp port to a host on my network. If the destination host is in the same subnet like the asa and the gateway of the host is the inside ip of the asa, all works fine. Now my question, is it posi...

m.leuschner by Community Member
  • 902 Views
  • 4 replies
  • 0 Helpful votes

We are in the process of implimenting SSL VPN using the AnyConnect client. I am curious if it is possible to have a Pre-Shared Certificate that is self signed created and then I would manually install the cert. This would ensure that I control who ac...

jstabl by Community Member
  • 1022 Views
  • 3 replies
  • 0 Helpful votes