Network Security

I have a Cisco 1811 at a SOHO office. It has 2 router ports and 8 switch ports. Currently one of its 2 router ports is connecting with an ADSL ISP and another one is disabled. A GRE/IPSEC VPN is setup on this Internet connection to the Head Office.I ...

Dear Alli have an IDS sensor 4235 , i upgarded it fron vesion 4 to verion 5.0(1)S149.i ensured from that the new version is installed on it . But when trying to access the sensor via IDM (its GUI interface) , it prompts me to enter the username & the...

Can you use the Management interface as another zone/security index to pass traffic like all the other interfaces.

Hi,We want to create ipsec site to site tunnel with multiple(3 to 5) site thru internet, pls. suggest a products that is worthy both costing n functional.we are using ASA 5505 at remote site

Hi allFriends, I have 2 ASA FW 5520 and 5505, and they are connected with each-other VIA VPN. I have mail server MS exchange, Domain, Share point and etc... inside 5520. And my question is next: Is it possible that users from 5505 could send and rec...

Hello,I have to setup two port redirections on our PIX. I need this two redirections:Outside-IP 212.6.1.1 to SSN 10.10.10.2for port 443 (HTTPS).Outside-IP 212.6.1.1 to SSN 10.10.10.253 for port 23 (Telnet).The access should be possible from any sourc...

I currently have a 3725 + the NM-CIDS module doing my firewall / IPS / VPN.I'm considering upgrading to a ASA 55xx box. I was reading the product page, and it does not seem that I can have one ASA box that does both the IPS with an AIP-SSM-xx and the...

Greetings,I have been able to setup failove for two Cisco ASA devices and they seem to be functioning- used two physical Interfaces, one for LAN and one for State as those resources were not needed for DMZ or things like that.Now, My question migt re...

Using DefaultL2LGroup tunnel-group, I am able to bring up a L2L tunnel from an IOS Cisco871 hub that is dynamically addressed to a static spoke ASA running 8.x. Authentication is via PSK. How can I use a tunnel-group other than DefaultL2LGroup? It se...

Hi,I need to add a user to my ASA, but at a very limited level, but just realised I have no idea what the 15 levels are, can you help?Thanks

Hi all,I need to configure an inbound nat rule on a PIX firewall so that a network that comes in through a VPN on the outside interface translates to a dmz interface (PAT).I have the configuration in place to setup all the translation rules without t...