Network Security

Dear sir,iam having pix 515e firewall now iwant to implement ipsec vpn and point to pint plz give me the examples how can i configure.Regardssrini

My customer says that performance through the FWSM was very sluggish. He said he switched over from active to standby FWSM and everything is fine after this.I want to ask him to switch back to the suspect FWSM module again to see the problem first ha...

I thought I was following this how-to and it seemed straightforward:http://www.cisco.com/en/US/docs/security/pix/pix63/hw/installation/guide/515.html#wp1048874But the primary cluster is not copying the configuration over to the secondary.I configured...

I have an asa 5520 currently running with a t-1. I would like to add a physically seperate t-1 to load balance ..is this posible? 2 seperate isp routers.

Having trouble configuring an ASA 5505 with a DSL modem. All interfaces show "up" but there is no internet. thoughts??

CISCO-PIX-515E:I am NOT exposing port 445 to the internet (as I have no need or disire to do so and am well aware of the security issues) - but I have noticed that one of my DMZ hosts (an SSL VPN Server) is trying to pass 445 traffic internally - so ...

Hi,s/w- 3.1(8)Can anyone guide me how to configure fwsm in transparent mode with multi conext.Is it ok with a sharing Interface between MSFC & FWSM (all the contexts)I beleive dynamic routing protocal is not supporting in any of the modes with multi ...

We have a 506e, that has been up and running for about 2 years with no issues. This morning a janitor accidently pulled the either cable going from the Outgoing Port to the Router out of the PIX, then instead of pluging it back into the same port, th...

Hi,I want my Remote Access VPN to work to our new PIX firewall Cisco PIX 515E. With AAA to a radius server.I want the Cisco VPN client to come with a popup which in I can fill in my details coming from the radius server.I configured the AAA server by...

is there any way to configure the pix 506e for a dynamic outside IP address

Hi anyone!Have a problem with fragmented packets trough different ASA55xx boxes.My ISP have tested the infrastucture and packets up to 1500B are delivered to my outside interfaces, but trough the ASA's i can only get packets up to 992B (ICMP) and whe...

Hi,Could I Disabled the "SYN flood" control in the ASA version 8.03 ?The IDS Module is disbled.Is it posssible ?Thanks

Hello!Is it possible to create redundant interface for subinterfaces or is it only available for physical interfaces?I have one ASA connected to two C3750 which are stacked, and few VLANs that are connected to ASA's subinterfaces via trunk.Thanks!Mar...