Network Security

Hi,Does anybody know if the FWSM is going to support EIGRP routing in the future?Kind regards,Michael

How can I configure a FWSM to send a syslog message when a context reaches a resource limit?Thanks.Andrea.

We have 9 small sites connected using Pix 501s to a central location over the Internet. All of these sites are running VPN tunnels (IPSec esp-3Des esp-md5-hmac) and using IKE 3Des, MD5, DH group 2 with preshared keys. The central location is a VPN 3...

HiIm running into a smaller problem when trying to reach my ASDM interface on my ASA5510My logs tells me thisThrough-the-device packet to/from management-only network is denied: tcp src outside:192.168.10.37/6545 dst mgmt:192.168.10.44/443This is my ...

Hello, I resetted my ASA 5505 back to factory-defaults. By running configure factory-default from the console. It erased everything except the enable password. How can I erased everything including the passwords.Thanks

Used the ADSM to create a startup config. Since we are not using NAT do I have to create an route from the Outside interface to the Inside interface.

Hello, I am trying to configure preshared keys and crypto maps with hostnames instead of IP adddresses. I have one site (hub) that is on a dynamic IP and multiple sites (spoke) with fixed IP's. I opening a new office that will have a fixed IP and nee...

Hi, from the Internet I can ping our ASA's outside interface, should this be liek if not how can I stop it?

I am attempting to install the 5.2 CSA MC on a Windows 2003 server w/ SQL 2005 locally. The SQL server permissions are tightened down, but my login has complete access to the server (both OS and SQL server). I also followed the install instructions ...

Hi, I'm having the following issue: there's an application that pings a host with 5-byte pings. The PIX (7.2 software) won't forward pings unless they have at least 20 bytes of payload. I can also generate the pings with the DOS command ping x.x.x.x ...

I use FWSM as multiple context routed( version 3.2.4 the last) , I use a share vlan as outside and 2 contexts and differents networks and vlans as inside. Contexts are admin and context1.I don't use any nat rules but when I generate traffic I have th...

I am wondering if below configuration is possible , Supposing hostA is behind pixA firewall wants to communicate to HostB behind Pix B , source IP (192.168.1.2) should be Natted to 172.16.1.2 ,however if it needs to connect to internet it can go a...

I am in the process of migrating from a checkpoint to an ASA5520. One issue that I haven't been able to resolve, yet, is that outbound active ftp sessions fail when using the global ip address. (I haven't tried a static nat, but I'm about to.)I have ...