Network Security

I have a customer with two ASAs; in Active/Standby. They want to purchase one AIP. Will failover (without the AIP functionality) to the Standby work if the AIP is configured for Promiscuous mode? Thanks, Bob

hi ,I need help, Can IDS event viewer version 4.1 monitor the IDS-4235-K9 with version 5.1-5-E1 ?

Hi There,We are currently looking at building out our Data Center to support a managed backup solution for multiple clients. We are currently looking at pushing the backups through a pair of ASA5580-20 appliances, however I have concerns as I haven't...

What command for PIX is equivalent of logging synchronous for router. I would synchronize typed characters with output from logging.Thanks a lotnowy

Hi All,i was reading the config guide for the Cisco PIX Version 6.3 IOS, i noticed there is no clear procedure for downgrading the cisco pix from this version to version 6.0.there is a procedure for downgrading to version 4 and 5.here is what in the ...

Questions: is there a way to create a network group using wildcard? I need to allow access on a 10.0.0.0/8 network that is segmented in 4000 smaller network. However, within these smaller networks only the 10.*.*.11 need to use port (21,137,443). Is ...

Hi guys,I have 2 firewalls ASA5550 in failover mode, in the data sheet says that maximum throughput is 1.2G, but when the outside firewall traffic comes up to 750Mb, i start to have a lot of problems, like packet drops. When the traffic arrives at 80...

Hi, i have two 3845 router with AIM-VPN/SSL-3 running C3845-ADVIPSERVICESK9-M. i have configured HSRP on this router. Remote site establish tunnel with this HSRP IP. I want to know whether stateful failover can be configured between this two routers....

How are the restricted license applied. If I have a 5505 how do you know if you exceed the 10 user restriction

I have PIX 525 v. 6.3. I have CS ACS and it's ok with authenticating the PIX login. But I couldn't get accounting data from the ACS for the PIX, like the commandds enterd, anything the PIX admin has done. The ACS accounting works well with other cisc...

i am not able to login to PDM3.0, it is showing me the error that Configuration problem.i can able to login to PIX510 by telnet, but i cant able to login using https:// mode.what could be the possible solution for this.

Hello,I am trying to enable threat detection with scanning-threat shun. The commands took with the config but when I run any nmap scans the ASA does not shun the host. What I am doing wrong?Thanks,Curt