Network Security

Hello,I'm using Cisco Pix 515E, 8.0(3).I have two networks - inside and dmz. Inside has sec. level 100, dmz 50. To communicate hosts from inside to dmz I made static (inside,dmz) 172.16.0.0 172.16.0.0 netmask 255.255.0.0 tcp 0 10.I think that Pix dur...

I have a local SQL 2005 database that I connect to via an ODBC connection. Lately I have noticed that once I connect to a Remote database via my VPN Client the connection to my local SQL database is lost, and stays lost until I reboot my system.I am ...

I setup my ASA5510 with a 3rd Party Certificate for SSL VPN's. How do I go about backing up this certificate if I have to replace the device? I already have a copy of the config. Is that enough? Thanks.

I have the outside interface setup for DHCP that connects to comcast.My inside interface is 192.168.69.1 and is setup to provide DHCP for my internal LAN. I have never logged into a firewall before and as I quickly found out the commands are not like...

I have installed the cisco VMS entprise edition. But whenever i try to configure it, it gave me error of DCR server is not running. Though I have restarted it so many times and even restarted the service but still getting the error. dont know what is...

I am trying to route traffic from 192.168.255.0 /24 to a host 10.213.121.236. The traffic is being killed off by the pix and i can't see why. Does this version PIX Version 6.3(1) allow recognise 192.168.255.0 as a valid network?

Hi, I have mangaged to connect to my Cisco ASA 5520 from the internet via the Cisco VPN client. I just used the ASDM wizard to create this. But I can't connect to any internal servers, or any thing really. I have yet to add any access rules but the w...

I need some help with a setup for email.SetupI have a PIX525 and an ASA5510VPN and an internal 2950 router. The PIX does firewalling and the ASA does VPN. Currently all outbound Internet traffic goes through the PIX via the router with this command:i...

PIX Devices Running Versions 6.2 and 6.3"Issue the activation-key command in order to change your activation key if the PIX currently runs versions6.2 or 6.3." Why do I have to do this ? Thx, [email protected]

Guys.Everytime I try to launch User Tracking, it shows that it failed to connect to the ANIServer.I've tried restarting the ANIServer which didnt work. I even ran reinitdb.pl (with and without the -restore switch),which still failed. Appreciate any h...

I have established a site-to-site tunnel between our two office bldg's, but I'm unable to ping between the two. Both IPSec and IKE negotiate and show active connections, but if I check the IPSec tunnels in the VPN status monitor, there are no decapsu...

I have activated the ARP inspection at FWSM of Cisco 6509. Is there an SNMP MIB to show ARP table info at FWSM of Cisco 6509? The "ipNetToMediaTable" MIB does not return anything.

I am configuring an ASA5520, which is acting as a Certificate server.The CA server is enabled and I have issued some client certificates.I have enabled the following commands:webvpn enable outside ssl certificate-authentication interface outside port...