Network Security

Can I configure ASA5520-DC-K8 with ASA-SSM-AIP-10-K9= IPS service module???

hello,i have configured my ASA 5510 for nat as:global (outside) 1 55.55.55.11-55.55.55.15 netmask 255.255.255.0global (outside) 1 55.55.55.100-55.55.55.160 netmask 255.255.255.0nat (inside) 1 192.168.15.0 255.255.255.0static (inside,outside) 55.55.55...

How do I show a QoS is working on a Pix? Just added a http policy that's all.

As well as running the usual firewall functions, how many DHCP clients can a 501 take before any slowdown occurs?Cheers.

i have a DMZ with a www server and a ftp server - i cant ping between the two. if i issue a ping i get one reply then 3 failures - if i wait about three minutes i can issue the ping again get one reply the the rest fail. i can ping the switch from th...

Hi, IPSec tunnel is running between 2 sites.Now we need to configure static NAT for 1 IP address comes under overlapping subnet.When we configure static nat then whole traffic is transfered to the static nat connection and my tunnel see not traffic.A...

Have a pix501 and it is setup w/ and isdn line. Now I will be changing the isp to road runner cable modem what things will i have to change in order for this to work?

if i am using basic licence, how can i upgrade to security plus?

Is there a way to have 2 seperate t-1's connect to an asa5520 for load sharing? These t-1's are on seperate physical routers and subnets.I have 1 t-1 hooked up and working and i would like to add another t-1. I do have a backup asa that is flashed bu...

Is there any issue regarding installation of a FWSM version 3.2 on a 6509 switch currently configured with a Sup720 version 12.2(18)SXD6 ?Cisco announces that support for FWSM 3.2 required a 12.2(18)SXF and higher...Thanks for your helpFrans

i have two 5540 between two different lans (primary and disaster)which i need to connect for syncronizing purpose.i use a point to point connection between the asa's.the asa has two interfaces configured at the moment, one is the primary (wan) and th...

Hi all,I have a big problema of dayly increasing memory usage on asa 5510 8.03.I turned off statistics and threat-management saving 50MB but the memory increases of about 10MB/day.Once already crashed.Please let me know if you can help me.Thanks

I have bsnl routerpix outside 192.168.1.101 255.255.255.0inside 192.168.10.1 255.255.255.0 lan network ip address range 192.168.10.101 - 192.168.10.250 pix configuration with command promptPix CONFIGURATION1) Enable2) Hostname3) Interface e0 auto I4)...

Does anyone know why our PIX 515 would lose some of its configuration lines over time even if it is never shut down?I have to keep re-entering some of the access list lines because they just seem to disappear