Network Security

Hi, Are there any feature in the ASA that act like Policy based routing, so I can redirect certain traffic through certain interface.

It's been a while since working with PIX firewalls and one of ours in a remote location is starting to develop hardware issues (CPU fan). Trouble is, we've got it set to complete a static VPN tunnel to the location where I'm working at and the tunnel...

HiHas anyone an idea how to get CS-MARS to properly parse custom signatures from an IPS 6.x? MARS seems to disregard both the name of the signature,severity and the new-to-version6 MARS category and regard everything as "Unknown event". Not much of a...

Hi, I'm looking for a general steer / experiences in implementing this using an ASA. Colleagues are steering me down a route of Microsoft ISA to provide thisfunctionaility.I kinda hope I can just use the ASA. Many Thanks,

Am in a spot of bother with getting my SNMP management station (running Solarwinds) to poll a PIX501 firewall at a remote location connected via VPN. The remote PIX501 had its peer changed from the PIX535 to a VPN Concentrator that sits side-by-side ...

Regarding Exchange7, it has been recommended for optimal Direct Push performance that we should increase the time-out value on our PIX525 firewall from the default to 15 to 30 minutes. Could you let me know how I determine the default value at presen...

I have a problem with a PIX 501 that allows you to establish a VPN session to a remote network (using the Cisco VPN client software) but does not permit you to ping any devices on the remote network. This problem only occurs with the PIX. I have simi...

Hi,We have CSA MC 5.1 runing and want to denay all spyware and some network access (snipping,icmp) to deny. I created customs Policies with rule modules for Application Install and network access and given Prioty Deny as Action but still I can instal...

Hello,I am trying to use the 7.0 ASDM after much heartache with the CLI. After doing much configuration on the CLI and then trying to access the ASDM I encounter a username and password window. I leave it blank and it doesn't grant me access. It asks...

Not sure yet if this actually is a firewall issue…I am deploying a boot/build server. The DHCP and Boot Servers are on different machines but the same subnet. Clients on the same subnet as these servers are working ok however, with clients connecte...

I may be having a possible issue with CSA 5.2. I am hoping someone out there can lend a hand. All CSA agents are in test mode (supposedly nothing is blocked, but events can be logged).Every now and then, a host with the CSA agent does not get a DHCP ...

I am at a Customer site today and am having a bizarre NTP issue occur.The customers outside Perimeter Firewall gets his NTP time from the Border Router (which syncs to tick and tock).I ran debug ntp events/debug ntp packets on the ASA, it gets a mess...

I have a Pix 506 that I'm trying to intergrated as a perimeter firewall.I've looked over the config and see no issues yet I can never get any inbound web services to function off of any of the static NAT statements.Both outside and inside interfaces ...

Recently we configured an IPS 4240 for our customer. We used two of the Interfaces and configured them as an "Inline Interface Pair" and put them between the customers Edge Network and their DMZ.While letting the Engine run last week, each time the I...