Network Security

Hi all, Hi have an ADSL router with dialer wan interfaz and negotiating IP with the ISP. I am doing NAT as well. I have several static PATs configured for publishing some services. I have no ACL configured more than the one in vty line for ssh access...

Upgraded a 5510 to 8.0 yesterday. At some point last night all access to inside services from the outside stopped. After several hours of complete frustration today trying to get it back up I found that a command had been added. sysopt noproxyarp out...

Hi.I having a problem.I am using an single ip address in the local pool.The first connection is asstablished.But when i disconnect and the reconnect, i get the error"no ip address is assigned".When i look at the vpn router the only address in the loc...

Hi,I have 7.0 version on ASA 5520 with UR license. I want to upgrade it to 7.2.2. Do I have to manually enter activation key after upgrade? If i have to do that, what is a procedure: show activation-key before upgrade, and afrer upgrade activation-ke...

how can i configure GRE tunnel over FWSM?IS this possible? Is there any Doc for that issue?Can anyone verify if FWSM or Pix(7.2) support GRE tunnels? We'd like to pumprouting info across it and we're not sure if it is supported. I've donesome researc...

Hi.Has anyone set up ACS security for SSL/Webvpn Tunnel Groups on the ASA.I want to set up multiple tunnel groups for different SSL VPNs and control Authentication via ACS.How do I ensure that when the user has Authenticated, he can only access a par...

Hi! I configured a remote vpn on a Cisco Asa 5510 (ios 7.1). All clients which establish a vpn connection can ping or reach other servers on the remote lan, but the Cisco Appliance doesn't assign them a default gateway - it remains empty. With operat...

I need to set up a site to site vpn but the company I need to set the connection up with needs me to change the ip addresses of the systems that they will connect to due to having the same ip subnet on their end. So for example they want me to mask m...

I have just configured the firewall with all the standard configuration but I can not gain SSH access. I have attached the running-config below, can someone please let me know what am I missing. I have configured the SSH exactly as stated at :http://...

Hi,We have a Cisco ASA Setup that is configured for VPN for Remote Access to our Internal Network.Without any configuration change on the firewall, we have observed that even though the VPN gets connected, no active traffic passes through the VPN Tun...

Hi,I cannot find this command sysopt route dnat in Pix 7.1. Any idea is this command deprecated or enable by default.Are there any new commands that should be considered for hardening of Cisco PIX firewalls?

GreetingsAs per my network setup, the scenario will be that the server on the untrust side will send data to the server on the Trusted site.I have received in total 3 IP Addresses from the UNTRUST NETWORK PROVIDER those are as follows:1. 10.150.39.25...

Hi, how can I set 3 ip address from different networks in the same physical interface in an ASA 8.X?I have tried setting one ip for the interface and the other two with static translation, but it doesn`t work.for example an echo request from outside ...

We have a Cisco Pix 515, with a Quad card for DMZ's. I would like to know if i can monitor one of these ports? I want to know the IP's going through it and their ports and destinations, possible?