Network Security

Hi,I have a problem with a Windows XP station with SP2 in the NAC DOT1X environment. I've already installed the SYMANTEC ADF file in ACS with success.After I've installed the SYMANTEC client v. 10.1.0.394 in the XP station, it don't put any file and ...

Hello all,I was wondering where I could find the PIX 501 documentation for version 6.3(4) of the firmware. I have the 7.0 firmware documentation and a lot of the commands aren't working like they say they do in the documentation.In particular I need ...

HiI am using before 4215 IDS in my network.My question is what is basic difference IDS and IPS ?. why I am using IPS in place of IDS , what is the key point and benefit ?.Thanksbiplob

I was wondering if there is a suggestion on the following issue:On a Cisco ASA I have configured third interface (other than inside,outside) to be used for VPN traffic.There is no problem with L2L tunnels since the remote IP is known, so it is easy t...

I am implementing a network with an ASA 5520 and an ISA server. I would like to hear input from people who might have done this before as to what the best setup would be for this? Having two firewalls would enable a layer of protection behind the per...

So I finally got my 506 up and running. I have internet access and inbound requests are being directed to the correct servers (smtp, http etcI have noticed many have ip verify reverse-path enabled. Is this a function one would normally enable as a 'b...

What is the processor/processors in the ASA 5540?

I am in the process of configuring my ASA5505. I have the Security+ license. I am finding that I have no choice but to use VLANS and then switchport my E0/* interfaces. Is this true or can I somehow get around this setup and assign IPs and Names to E...

Hi Experts,We have 2 ISP's consider SP-A and SP-B. Both are connected to Router. We have default routes on Router to SP-A and SP-B. Router is connected to PIX. Patting has been performed for both the ISP's. Now I need some redundancy on PIX so that S...

I'm configuring a couple of FWSM's (2.2 and 2.3) as devices in MARS. When I add the FWSM as a device, what do I enter as the device name and reporting / access IPs? Should the device name and / or IP info be the same as the FWSM's admin context? or s...

I am in the process of upgrading my Sonicwall to a Pix 515e (IOS 6.3(5)). So far I have the new config working great except for one problem which I have not been able to find a clear answer. I have two interfaces outside 0 (a.b.c.0) and inside 100 (w...

I am trying to shutdown my sensing port on an IDS 4235 since I cannot seems to get the latest software FTP'ed over. I can do it on another so I am positive I am doing the ftp correctly. I tried "conf t" "int sensing 0", it says the commands are depre...

iam still new in this security world.i am using cisco ASDM 5.0 for ASA.How can i block Instant messenging like Yahoo messenger and msn messenger. and also how can i block p2p apllication in my network envirenmont? lastly how can i monitor network uti...