I was under impression that for S2S tunnel on each side that along with NAT for the tunnel that one has to define firewall rules for remote tunnel access through outside interface to inside interface and that also from the inside interface a rule all...
Hi Guys I was trying to create a document with Peer IP, Crypto, Private IP, IKEV version and description, tunnel status. Is there anyway to get all there details?Thank youNiK
Hi folks, I have newly deployed 2 Ftd's in A-S HA, via FMC.Under Device tab of FMC i can make interface changes for the Active FTD, how i can do the same for standby FTD ?I want to add a new subinterface on both FTDs, but i am unable to do the same ...
Hi,I am trying to enable http server on cisco asa v with command : http server enable but I get an error :Could not start web vpn to start ladmin listener Do anybody has some idea about it...Please suggest.. Thanks Mandeep
Firepower is setup with ASA behind it. Need to setup IPSec between ASA and Outside/internet JuniperFW. I can see IKE and ISAKMP packets, but no ESP. Is this even possible:-Use FMC to traverse IPSEC for an internal ASAAny inherent policy in FMC that b...
Am I missing something or is it impossible to find a download for this? I have a valid cisco support account & constantly download software all the time. Can some please guide me?
If the AGE of the arp entry increases does this mean the device is offline.In this exampe the age of 10.59.33.25 is 194 Minutes and increasing.DRWEXTRTR02#sh ip arp vrf OPTUS-SIPProtocol Address Age (min) Hardware Addr Type InterfaceInternet 10.59.33...
Hello,I am attempting to create an IPSEC site to site tunnel between two sites. When i attempt to ping a host in the CoLo from Dover (192.168.10.239 pinging 192.168.190.200), the tunnel establishes, and i see bytes rx and tx on the Dover end of the t...
Dear All,On our ASA(9.18), we are running OSPF and BGP, and are redistributing BGP routes into OSPF.We want the redistributed routes to be tagged with a custom route tag. However, on ASA there is no option to tag routes using set command under route-...
Hi Folks, In a plan to upgrade my ASA, ASDM and FMC, below are the current versions Cisco ASA 5525: 9.12(4)37, ASDM Version: 7.13(1), FMC : 6.5.0 Looking for ASA-FMC compatibility matrix
Hi Team,How can i configure MAC Address to IP Address Binding on Cisco ASA FW? I am migrating Domain controller to Cisco FW, i have configured DHCP and DNS on it. Now I have 7 IPs which needs to be configured on MAC address on this FW.
Hi, We have problem with Teams when connecting in vpn . I would like to configure my vpn anyconnect to be split tunneling (exclude teams traffic only). I saw a few configuration suggestion on that some with Python script and some with dynamic exclu...
Hello!I'm using Arctic Wolf for security scanning, and they're telling me that port like 135 and 3389 are open. I have an externally accessible server with 1 to 1 NAT setup, then my ACLs only permit web traffic. When I do a packet capture, and try to...
I am working trying to limit users to certain sites within a domain using manual url filtering.I have a rule that blocks discord.com which worksI do want users to be able to access certain channels within discord.source: internal networkdestination: ...
Hello Team, I have been through lots of Cisco FTD Docs and cannot find the answer, trying not to raise a TAC case for this if it can be avoided. Does anyone know if you can modify the SSH cipher on FTD by editing "/etc/ssh/sshd_config" on Cisco FTD 2...
