Network Security

I have a Pix 515e that I need to forward a port. this should be a simple task but for some reason it is not working. I have attached my config file I need to forward FTP to mcs-sbs01 I have the nat setup in the config I attached it has ** above and b...

Trying to find out what the command would be to make a "Comment"Thank you.

Hi,Actually , i installed CSA MC on a server (its name CSAMC.NMEG.Loacl), and i tried to install the CSA on a group of servers . The CSA MC and these servers are in the same domain. One of these servers (its name EG-NMEG-BACKUP.NMEG.LOCAL)is register...

We are using Cisco Security Agent 5.1.0.79. We have 491 clients, mostly Win XP.We have noticed that within 3 days of CSA installation on a PC, WMI quits working. If you try to connect to a PC using wmimgmt.msc, you get the message: "Failed to connect...

Hi I am getting the following errors when trying to ssh between 2 servers over the VPN tunnel. I see it is going out of my acl_inside access-list but I do not see it reaching the VPN acess list. There is no natting between the 2 ips.# no natting for ...

if I purchase ASA5510-SEC-BUN-K9 bundle, will I get two units or just one? In case of just one, what exact part no must I order in order to have two units in failover?thanks

I have some questions regarding an access-list applied tinbound to a DMZ interface.1. If the firewall is stateful, and the NAT statements are set up correctly, then anyone from an inside interface should be able to access anything on the DMZ interfac...

I made a simple pix config for inside to access internet,,,For tht we have purchased 6 prublic ip's from isp provider, i m using one of the ipinterface Ethernet0ip address 202.63.101.68 255.255.255.248 interface Ethernet1ip address 10.50.0.200 255.25...

ASA Version 7.1(2) !interface GigabitEthernet1/0 media-type sfp speed nonegotiate nameif inside security-level 100 ip address 172.23.192.68 255.255.255.248 !interface GigabitEthernet1/1 media-type sfp nameif outside security-level 0 ip address 60.13....

Where can I find MTBF data for the ASA 5505 and 5510 ?

Hi to all,I would like to know how I can restrict the users (by source IP) that can access to a specific object-group.In my case I have different groups to establish a VPN with the internal networks for different intentions, one of them if for manage...

Hi , My standby pix firewall , presently is in failed status .Its IOS is 6.3(5), please help on this .What could be the reasons of my standby failover going in Failed status ? I am not able to get into the PIX via Console also.regardsNeo

I have a Pix 506e connected to the network. Symptom: If a PC user is not connected with their pc on when the server is rebooted then the Pix needs to be turned off and on for it to allow Internet access.Is this a configuration error, failing hardware...

Hi, I am trying to setup a Cisco 1841 VPN tunnel for a Netgear FVS14 at a remote location. I have tried the SDM and everytime I submit the rules, the 1841 locks up and reboots. I can create a site to site VPN with dymanic IP (remote) correct?