Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
I get a BE4K few months after it came out as a PoC for some potential future deployments. I liked the technical specs and the pricing model that Cisco offered with the BE4K.
Since day one, my experience with deployment has been a ...
Hi Voice Gurus,I'm having an issue with a AIM-CUE and CCM when configuring AA ...Environment is:CCM 6.0VGW 2811 + 4 FXO VIC + AIM-CUE running 7.1Signalling is MGCPThe FXO card has GSM terminals connected to it fo...
Hi All,Does the TelePresence C20 require any version of CCM to run?I'm looking for a quick video conference kit between 2 sites and was looking into the Polycom and LifeSize products but found that the C20 is reasonably priced?Any pre-requisistes oth...
Dear Gurus,This is my first time working on the outdoor mesh APs and I wish to ensure that I'm putting the right part numbers together.Client is a factory with a 200x220m open space with heights ranging between 10-14 meters. Customer has carts, handh...
All,I have a requirement to connect some branch offices to a central site using a legacy TDM network with E1/G704 circuits. The telecom provider will provide an E1/G704 trunk into the central site and similar connections into each remote location and...
I had this issue today and I ended up calling TAC. With the new IOS-XE, you will get all the Viptela stuff which means your basic commands won't work. So "Configure Terminal" is a no go (yes, it's that bad !). The command is "config-transaction". The...
Thanks Paolo ...But how can I tell CCM to forward the incoming calls to the voice gateway which has the AIM-CUE card? Keep in mind that the calls that I'm expecting will arrive on FXO ports and not E1 PRI.I tried to find a configuration example on Ci...
If you're going to hit 100M then I would go for the 3800 (probably 3845) ... at the end, it's more of a commercial decision ... overspec the box and don't underspec is the easy answer.S.
Have a look at the Cisco Portable Datasheets under router performance and you'll find:Cisco 2851 (220Kpps / 112.64Mbps)Cisco 3825 (350Kpps / 179.20Mbps)So the question will be, what is the speed of this circuit and what are you doing with it? If it's...
