Network Security

Hi all, we would like to create some IPSec's as our backup links to a datacentre using the Cisco ASA5510, the connection will be between a Cisco 2600 and the Cisco ASA5510 across the Internet. Can anyone advise of a way that we can do this in the bes...

Hello, I want to configure a router CISCO 800 adsl, with a firewall behind. Does somebody have some configuration of this type?. Do I need two public ip, one for the router and another for the fire wall? Or with a public ip it is enough? In other rou...

I am trying to obtain the logs of activites that occur on the PIX and send it to a vendor. I look at the commandline and GUI but do not see anything that allow me to view activity logs. Can someone please tell me how I can obtain this information?

Hello,I would like some configuration example for configuring PAT on PIX 515. We have 5 public IP addresses and around 20 machines that need to be published with public IP addresses, they include webservers and mail servers, and also a larger number ...

Hi, i want to view my running configuration with only IP addresses is it possible on the pix ?Thx

Hello,I have spent an entire day trying to figure this out, but have to ask for help.Here is my setupoutside 10.10.6.243 (10.10.6.240/29)newdmz 10.10.33.163 (10.10.33.160/27)olddmz 10.10.9.65 (10.10.9.64/28)provider has following set on their routers...

I bought a PIX 515E on 8-2-06. The device has been performing fine, I am also running DHCP off this device.Yesterday I had 2 PCs not able to access network or internet. It was discovered that they had a new subnet mask of 199.x.x.x vice 255.255.255.0...

Hi -I'm trying to share an IP address between two IP addresses using static PAT, which works fine. The problem comes with the IP address each machine takes when they send outbound traffic (i.e., e-mail). Both machines use the public NAT address for t...

I have been looking online and talking with TAC for a solution to this issue for the past couple of days.I recently have been testing a new ASA 5510 as a replacement for my old PIX 506. The issue that I have is the following:I have a 3560 switch whic...

Here is my configuration - per-se interface ethernet0 auto interface ethernet1 auto interface ethernet2 auto nameif ethernet0 outside security0 nameif ethernet1 inside security100 nameif ethernet2 DMZ security4 access-list outside_access_in permit ip...

To help with remote management of PIX 506E/515, I would like to understand if there is a mechanism of being able to:1. Write a custom agent, and install on PIX 506E, OR2. Call APIs published by the http webadmin interface, using some language

I got pix515E which is in rommon and needs IOS upgradation. can anyone quickly send me the link? it's urgent. thanks.