Network Security

I know the PIX525 has a cleartext throughput up to 330 Mbps. What would happen if I go above 330 Mbps ?Thanks

Does anyone have a sample config for an ASA to a 3030 Concentrator LAN to LAN tunnel? I can't seem to find one and it would be great if someone can point me in the right direction.Thanks,

Edward,Thanks for your info. I will contact the customer and dscuss those things.Also i want to know the following on IPS in-line setup.1.IPS Connected behind the firewall pix 525 in in-line mode. Interface pair was created and 2 interfaces are made ...

Hello Everyone,I am trying to understand the Cisco IOS firewall feature sets in regards to SDM.As I understand it, depending on the IOS, SDM will allow you to create any customized firewall using the Cisco IOS firewall feature sets.However, when crea...

Dear All,I've got problem with PIX515E port redirection: I can't reach a router by telnet and a linux machine by ssh.I've attached a doc document containings layout and configuration. Regards Alberto Brivio

I have an ASA 7.2(2) and I have a situation where I have to groups of users (students and staff) I am using WebVpn. So when I log into the webvpn page I get a dropdown with the 2 groups and when I login to Staff I get the staff services and if a stud...

I have a 3825 router that terminates client vpn connections and a remote PIX that terminates client vpn connections and tunnels to 2 other PIXs. I want to build a site-site tunnel. I have configured the 3825 as follows: crypto isakmp policy 3 encr ...

I have a Cisco PIX515 firewall that I'd like to configure and install on my LAN. I have managed a Cisco 3640 router installed on my LAN and prefer to put the firewall behind the router to protect my LAN.The LAN Gateway is 172.18.1.1 netmask 255.255.2...

Hi,I am wondering if when NATing the PIX outside interface IP on my border router if I will still be able to terminate both site-to-site and client VPN on the PIX by configurin the VPN clients and the remote site to establish the tunnel with the NATt...

What is the best possible procedure the PIX is placed at remote location.I only have ssh connection with it.Basically i want to copy the running configuration and the current IOS so i cant delete it and copy the new one .Plz tell me how to upgrade it...

Hello all, need help here. I configure an one to one NAT for a local machine in my LAN needing a publick IP as:static (inside,outside) 63.x.x.37 10.8.2.57 netmask 255.255.255.255 0 0When I check the machines public IP it comes up with one public IP ...

Hi, If I need to add a new rule in the middle of an exist ACL, do I have to re-write the whole ACL? Can I just add this rule to the right place based on access-list sequence number? Thanks

How to see list of users using a command from telnet instance to CiscoPix firewall 506eif there is a command to see the list of users , then how to redirect all the list of users in a file.