Network Security

When I try login to the cisco IDS sensor 4215 I write the correct login and password but it doesn't login me to the prompt , instead it asks again for the login after displaying the disclaimer.-----------------------------------------sensor login: ci...

All,I am running a Pix 515 with 6.3 code. When the VPN Connection is established, the default gateway on the PC is the same as the IP Address on the PC. The VPN Connection is made on the Internet Line in and the Internet Traffic, would obviously be o...

Dear Support,Wondering if it is possible to run a gre tunnel between two asa 5510's.we have two sites connected via a les100 and running ospf to inject a default route at each site, and these are connected to 3750 emi switches which also run ospf.wha...

I have several new ASA-5520 boxes. All are configured with version 7.06 (Cisco recomendation) and in active/standby configuration.The problem is that the ACLs seem to disapear. For example; I have an outside access list that have about 20 lines. Ever...

Hello,I have several site-to-site IPSEC VPN tunnels(using pre-shared keys) built from several 3640's(using FastEthernet) running IOS 12.2-17 to a VPN 7140 agragate(Also via FastEthernet) running IOS 12.2-15.T8. All has worked well for years. I am now...

It seems that 1330 and other normalizer sigs are causing Cicso (and myself) some grief (as evident in CSCsc37875). I am wondering if I can just disable 1330 and all the subs entirely. I am seeing this sig (1330/14 in particular) fire alot. I set the ...

Dear All I have PIX 515E with 2 interfaces, I have 4 Public IP addresses I want to publish my exchange server from the internal network I am able to access it by the public IP from any where through the internet except from my internal network, I am ...

Hello,Is there any news as to when the bug with the TCP Hijack signatures will be fixed? According to forum posts from March, the bug CSCsd00877 in TCP Hijack signatures (3250,3251)is being addressed by Cisco.I'm having the exact same problem (except...

Hi,I want to fix a connection timeout for a concrete rule. I know that I can modify the timeouts for all the connections (in the section Properties/Timeouts), but I don?t know if I can modify only for one connection.Thank you very muchBest RegardsNur...

Hi, I am having a problem with the inside interface of my failover pix. It is showing up/up on the pix and on the switch it is connected to. If I do a show arp, I can see the mac and ip ok. When i try to ping the ip from the switch however it does no...

Hi,I have a pix 515 E vers. 6.3(3). How can I back up thr current image to a tftp server?Tanks in advance

Hi does anyone know of any thing that might cause a problem with traffic going from one interface to another and have a big spped difference. I have a Pix 515E UR running 7.0.4 software i am seeing this problem between my inside and outside interface...

Hi all,I have setup a lab with a OOB VGW setup. I have setup an authentication VLAN on the untrust interface of my CAS on vlan 120 which is mapped to internal production vlan 20 when assesment is done. So far everything works fine except the default ...

Hay there,I setup a ASA FW with Trend Micro Content Security. When I add an URL to the block list I can still open it from the PCs which use the ASA as the gateway?! What did I forget?Lars