Network Security

What is the best and quickest way to find out what host has the largest number of connections to the PIX or is hitting the PIX the most with the most traffic? THanks to all!

Hi All, i planning to configure pix-515 firewall for my internet connectivity . can anybody suggest me the configuration. only http and exchnage traffi will pass on this link. following is the designe for my internet connectivity campus network with ...

Hi,I am facing an issue with a new 6500 router (IOS version 12.2 ) having a FWSM module. (FWSM Version 2.3(3)) which is like this:-I have three Vlans INSIDE, OUTSIDE and DMZ with security levels 100, 0 and 50 respectively.I have created appropriate a...

Hi how can i tell what throughput my firewalls are doing at the moment. I am also getting overruns and error, and we believe its beacuse the pix can't handle the trhoughput..... does anyone know were i can find this information

Hi Firewall Gurus,I'm just a bit confused with the NAT and PAT capabilities of a PIX firewall. For example I have this configuration:global (outside) 2 210.*.*.49-210.14.26.55 netmask 255.255.255.0global (outside) 2 202.*.*.34nat (inside) 2 10.161.0....

I would be grateful if anyone can enlighten me with regards to what I am doing wrong in setting up my asas5510. I?m unable to ping out to the Internet from my DMZ or from the inside out to the internet. I can ping devices on the inside and I can ping...

I'm about to suggest a NAC solution for our network but I want to know first what are the real life impacts of NAC (clean acces or framework). Does users have to authenticate 2 times (nac + ldap) ? Any network performance impact ? I need all kind of ...

I'm in the process of first time configuration of ASA 5510 using ASA 7.2(2) and ASDM 5.2(2). The Command Line Reference manual (7.2(2)) indicates NAT and PAT are features not supported with WEBVPN.Does that mean that the appliance must allocate routa...

I have taken over the managementof the above and have not been left a passord to enable me to get to config.I would rather not reset the box, is there any way round this issue, it is only a simple NAT I need to change.

Dear sir,i have a PIX-525-UR-BUN Firewall and i want to add a new Active/Active devicewhat is the part number license for this new devicethanks

Hi all, I have Catalyst 6513 + FWSM. Normally, I use the command "session slot 1 process 1" to connect to FWSM, and I only type password "cisco". Now, I create one usename "cisco" and then, I no username cisco. Now, I connect to FWSM and it asks me "...

I have a router that is 2610 with 12.3 ios ver, its already performing NAT with its two serial interface as outside NAT. Now its is experiencing degration like delay in sound and video conversation compared when is not in NAT. is it recommendable to ...

Hello, I'm researching the ASA platform I'm interested in Active/Active & Active/Standby configurations. I've not found any documentation (or configuration options) that would allow the IPS module to take part in the failover or loadbalance process. ...