Network Security

I have configured a vpn using the vpn wizard in my pix 501 6.3(1) firewall. The connection is established ok but i am unable to see the network resources i configured using the wizard. When veiwing the logs i found this entry 3 deny inbound (No Xlate...

I have searched for documentation regarding the order of operations for packet processing in the PIX 535 appliance for both inbound and outbound packets, but cannot find any. Does anyone have a reference as to what order ACLs, Xlate, Conn, and NAT lo...

Hiwhen I connect via Telnet/Ssh my PIX-506E (6.3(5)) after an indeterminate time I'm logged-out for connection reset.Pinging the PIX interface no packet is lost and this is definitly not a network problem.Does anybody experienced this kind of problem...

Hi,I understand that even with the latest version of ASA OS 7.2.1 PPTP is not supported, but would like to know is there any roadmap planned to support this feature on ASA as we are using this feature extensively on PIX and are planning to migrate fr...

I am having a problem getting the link up on port 0(internet). I am connecting to a speedstream DSL router. I tried both yellow and orange cable without success. When I plug in the cable for the first time, the green link light does come up but after...

Is there a way I can detect the BIOS version of my 4215 over telnet? It's at a remote site.

The 5.x sensor's allows you to set a login banner with the "banner login" command on the CLI. This fills some legal obligations, but I have not found a way to set this via VMS so that I can push this out to all my sensors in one update. Please tell m...

Does the Ip address on the SSM have to be on a seperate subnet from the other interfaces, while running in promiscous mode?

I have a PIX 525 (7.1(2)4)failover pair. I need to configure a new interface on the PIX. When I use the command NAMEIF and name the interface the PIX reboots. I have done this with the inteface shutdown and up. The results are the same.

Hi,although googling, searching cisco.com, cisco npc and so on I didn?t find a way to specify the DCE-RPC UUID to create an ACL permitting only certain DCE-RPC service through an ASA (and denying othes) e.g. allow: 469d6ec0-0d87-11ce-b13f-00aa003bac6...

I have 2 ASA version 7.2 with L2L IPSec VPN tunnels.I need to configure qos across these Lan to Lan IPSec tunnels with a Rate limit policy (2 Mbps for the http traffic, 1 Mpbs for the https and 500 kbps for all other traffic)As indicated on the http:...

We have CM LMS 2.5 and use it to manage about 15K end-user connections. We have some anomolies with User Tracking (UT)that I can't seem to resolve.1) UT does not seem to collect information on all the active ports. The device is active and IP/MAc are...