Network Security

Hi, My name is Zab and my issue is that my firewall (PIX 520) on startup asks for floppy to boot. Since I have no such floppy disk how will I change the boot option so that it can boot without a floppy on its own?

Hey guys. I'm looking for a new router security appliance. I would like it to be able to tell me how much bandwidth is being transfered over the wan and lan both for in and out. Like good logging/reporting feature. So if you download say 6gb from the...

I have a client who has multiple remote sites that use the Cisco VPN Client 4.9x to connect the Cisco PIX 501 at the main office. The VPN client connects just fine, stays connected for about ten minutes and disconnects. I have adjusted the parameters...

Cannot manage via https on public interface get 403 (not authorized) error. Managment via private interface is OK. Access rights are configured https is enabled. I have tried tcp:443 and reconfigured for tcp:8443 same outcome with traffic management ...

Can somebody advice me - where i can find information about configuring NAC L2 802.1x on wireless AP 1200 series? Or can somebody show me example of configuration file? I have found configuration guide only about wired solutions (configuring NAC L2 I...

We have a problem with running FTP through the PIX, either in active or passive modes.We have a fixup running for ftp on 21, the pix sits behind a perimeter router, and I have checked that it is not an ACL on it that is causing the issue.We are using...

On our PIX515E that runs PIX 7.2(2) and ASDM 5.2(2), if I enter an access list from the CLI it is not displayed in the ASDM. However the access list works and is displayed when sending the command 'show run'. This is the case for all the acces lists ...

Currently, the network topology at my workplace is the following:The main office/network (Fairbanks) is in the 10.9.x subnet, and connects to the outside world through a cisco ASA 5510 box.Users on individual computers can use a vpn client to connect...

Is there anyting like IPS Device Manager available for Trial Version that can be installed on windows machine for study purpose.for eg. there is PIX device Manager that can be installed on windows thxraju+91 9867791104

Hi all, I see in Security monitor: IPS database file: 119% (Usuage) idsmdc.db (28.94%) idsmdc.log (90.45%)Now, I want to ask, If I delete file idsmdc.log, Cisco VMS can run well or not? How to decrease the IDS database? Thank you very much.

I have a server on my internal network running Websense. For sake of discussion, the IP is 1.1.1.1Workstations on DMZ1, off of my PIX 535, are in the 192.168.0.0 255.255.255.0 networkBelow is what I have configured on my PIXurl-server (inside) vendor...

I have CW CSM deployed to manage the Pix and ASA firewalls deployed in the company. I have added the firewalls to AUS but some of them will not talk to the Update server. I have a dozen or so that will talk fine, get their updates and remain sync'd b...

Hi,We are trying to create an L2L tunnel Between a PIX 515 V.7.2 and a Symantec Gateway 360 V.2.1.0 Build 1336. We have been able to create a tunnel but it is really unstable ( UP 45min then down 59min...all the time ). Anybody heard about incompatib...

Hi All...i'm trying to enable ssh on my pix recently upgraded to v7.2 but same problem..nto able to access these things r also set..username hashmi pass xyzpasswd abcenable pass: jkl...debug output shows the following..SSH0: authentication request fo...