Network Security

I've got a 5.x sensor sitting on the public side of the network. The first two interfaces are paired and assigned to the virtual sensor (vs0). On the "inside" interface 0 is my firewall and proxy servers. On the "outside" interface 1 is my Internet r...

I have just installed ASA-5520 with SSM-10 module. I have the IPS working and running in inline mode. I need clarification on the anti virus features. We currently use Symantec anti virus. I dont understand how I can integrate the IPS and symantec to...

I tried unsuccessully to upgrade a PIX 535 with 6.3(5) to 7.1.1.The PIX erased the old version, but then gave an error message that the upload hadn't worked.I believe I've insuficient memory to try again.I haven't re-booted it yet, but if I do, I bel...

HiWe have two IPS modules installed in the ASA.When we deploy OPsig to the IPS modules, the event log show the deployment is unsuccessful.How can we troubleshoot this error?Thanks!

Dear All,Please let me know the products from Cisco to monitor and optimize the IDS, ASA, PIX firewall in the data centre and corporate networking environment.I believe that VMS 2.3 can be used.I like to know about the CS-MARS product from Cisco and ...

dear sir, i want to do the natting on the pix firewall which is having two interfaces E0---XXX.210.233.69 255.255.255.248E1 --10.1.105.1 255.255.0.0THE INTERNET CONNECTION IS CONNECTING TO 1711 ROUTER whos IP ADD XXX.210.223.66& pix is connected to t...

Hello,Is it possible to block only IM file transfers with the ASA? If not, will the CSC module be able to block IM file transfers?Thanks!

I basically followed the config example of cisco in :http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtmlit works fine.my pb is:the remote site has a 2Mbps line but once the tunnel is up, even wit...

Helo,i would like to update my two ASA 5540 witch is configure in failover mode (actif/passif) without reload the 2 asa simultaneous. is-it possible without problem if an asa run witch a version and the other with an another version.I would pass to v...

What does it mean:May 26 03:51:38 vpn-conc.mcc.cell.ru VPN-Conc %PIX-3-713902: Group = 194.84.x.x, IP = 194.84.x.x, QM FSM error (P2 struct &0x2654828, mess id 0xa7030dba)!???i did not find the message in error message decoder.

HiThe two ASA with IPS modules are in active/standby mode. When I try to add both the two IP (active/standby) into the MARS, the MARS will complain duplicated hostnames.How to setup MARS to monitor ASA with IPS with active standby topology?Thanks!

Hi,I have a 3020 Concentrator with one SEP-E module. I have configured sames as my other 3020 Concentrator. I use software vers. vpn3000-4.1.5.Rel-k9.bin. The problem is that after one vpn client "vers.4.8.00.0440" connection the Concentrator wont ac...

Why do we need DMZ interfaces? A document says that On the DMZ interface, we can install the servers that need to available for the public access and we should configure static nat.But I can do so on inside interface as well. Then why Security Levels...