Network Security

Do you need any license to configure WebVpn on 3725 router with 12.4(8a).

I have central office pix and remote sites that use dhcp from isp. central has static. I am attemping to setup tunnels that allow access between sites. tunnels appear setup, however, i am unable to connect to any thing at the remote sites. I can use ...

http://www.cisco.com/cgi-bin/tablebuild.pl/cs-mars

I noticed on my PIX whenever I reboot it, I can no longer see OSPF routes on my Inside Interface. Even the "Show ospf interface" command does not show the status of the Inside Interface. I had to remove the "router ospf <proc>" and reapply it just to...

I have a question about the "show fail" output below. Note that the secondary pix on which it was run shows "Active time" 4475970 seconds - about 52 days. But it shows the primary pix as "Active time 91301925 seconds - about 1056 days. How can the...

When i do "sh ver" over an IDS 4250XL 5.1(1)S243.0 it appears:...AnalysisEngine 2006_Feb_08_13.09 (Release) 2006-02-08T13:52:38-0600 NotRunning...What does it imply? How can i start it?Thanks,

I'm having a strange issue when uploading very specific files (ONLY .CSV) through my PIX firewall. For whatever reason, only this file format fails when users upload to any FTP site, and it always fails after about 65000(+/-) bytes. Renaming the fi...

I am using a PIX 501 to protect our internal network 10.0.0.0 (inside interface) from a seperate internal network 192.168.1.0 (outside interface) consultants have access to this 192 network, but I need to connect to machines on the 192.168.1.0 networ...

I am trying to install digital certs on my cisco asa 5510. I have created a ca trustpoint, (geotrust), and I am entering my keys manually, I have tried to enter the root cert, which it wants in hex, geotrust is in base 64 .cer file I will provide mor...

recently our isp require us to change the ip subnet we were using without, therefore we needed to reconfigure the pix515E v 6.3 by changing the outside ip address and other static translation with servers and exchange. but after making this transitio...

I set up a VPN connection btw c831 & VPN 3000. The connection is up but there is no traffic goes thru. I would like to know if I need to configure the VPN 3000 to encrypt the packets. If yes, how should I do it? In the c831 router, I have configured ...

Dear all,Goo Day,I have two Cisco PIX 525 with OS 7.0(1). In the primary appliance, there is UR license installed with the VPN-3DES-AES feature enabled. In the secondary appliance, there is an FO only license installed with the VPN-3DES only enabled....

Hi,May I configure my IPS (this is an appliance), not to monitor, analyse some network traffic? I know I can create filters for events, but I want to prevent my box from oversubscribtion, so I don't want to monitor some type of traffic with it.Thx

Hi Guys,I need some information!Is the IDSM2 hot-swappable in a Cisco 6509 Chassis?Recently I installed the IDSM2 on an Cisco 6509 Chassis (with two Sup720s in SSO mode). But chassis rebooted specifying that the "%C6K_PLATFORM-2-PEER_RESET: RP is bei...