Network Security

Are there any plans to update the FWSM code to support features similar to the ASA/PIX 7.x code? Features such as WebVPN, SVC and intra-interface traffic are some features that come to mind.

I have a 2610 in front of a Pix 506E. Attached is the cfg's of each. I think router is set wrong plz hlp.ROUTER ===>>!version 12.2service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!enable secret xxxxenable pass...

has anybody familiar with PPTP/gre? Here is my scenario:NT 4 inside-PIX-outside--internet --PCNT4 has PPTP server(MS built in) running inside the pIX. PCs over the internet are able to establish GRE tunnel. We allow PPTP/GRE por...

How can i define the internal networks for IDS 5.X? Thank you

Does anyone know if the ASA 5500 has support for Jumbo frames?

How to avoid duplicate IP address alerts from devices with HSRP and virtual IP configuration?

Dear Pros,Please let me know the IPS placement for the following network scenarios i am implementing for my customer-DSL internet connection terminated in Cisco 3825 internet router.-3825 inside ethernet segmemt goes to PIX failover pair outside segm...

Hello All,I have a PIX 525 configured with 3 interfaces (inside,outside,DMZ). This PIX is connected to a cisco core 4100R switch. I want to let a specific VLAN with a subnet (10.2.0.0) to remote desktop and ping the DMZ web and mail servers. However,...

I am wading into the art of rule creation in MARS. I wrote a rule and it doesn't seem to work. Then I took everything out of the rule such that it is "any" all the way across. Then I ran an "any" query using this "any" rule and I get no results bu...

I've setup an ASA to allow SNMP polling from a monitoring host internally. I fired up an SNMP browser to see what kinds of information I could get, and tried to look at the supported MIBS that Cisco lists.What I really want to get is the bandwidth ut...

How can I route two ADSL?s from the pix? Each ADSL is in a different PIX interface, each ADSL is offering internet sevices, but I can only set one default route in the pix, so the responses from my server goes out for the same ADSL (the default rout...

Hi,I was wondering whether there is a way to tell the firewall to display the IP addresses of hosts and networks rather than the names that have been configured with the names command when I do a show run.The obvious problem I have is when I want to ...

HiSomeone please help me,i need to upgrade to a 3DES/aes license, i found pix firewall license free at this link https://tools.cisco.com/SWIFT/Licensing/PrivateRegistrationServlet,in title it says that it is for Cisco PIX Security Appliance 3DES/AES ...